HP Pro 6300 manual Control panel message Description

Table 9-1Numeric Codes and Text Messages (continued)

Control panel message Description Recommended action

162-System Options Not Set	Configuration incorrect.
	RTC (real-time clock) battery may need to
	be replaced.

Run Computer Setup and check the configuration in Advanced > Onboard Devices.

Reset the date and time under Control Panel. If the problem persists, replace the RTC battery. See the Removal and Replacement section for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement.

163-Time & Date Not Set	Invalid time or date in configuration memory.
	RTC (real-time clock) battery may need to
	be replaced.

Reset the date and time under Control Panel (Computer Setup can also be used). If the problem persists, replace the RTC battery. See the Removal and Replacement section for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement.

163-Time & Date Not Set	CMOS jumper may not be properly installed.	Check for proper placement of the CMOS
		jumper if applicable.
164-MemorySize Error	Memory amount has changed since the last	Press the F1 key to save the memory
	boot (memory added or removed).	changes.
164-MemorySize Error	Memory configuration incorrect.	1.	Run Computer Setup or Windows
			utilities.
		2.	Make sure the memory module(s) are
			installed properly.
		3.	If third-party memory has been added,
			test using HP-only memory.
		4.	Verify proper memory module type.
201-Memory Error	RAM failure.	1.	Ensure memory modules are correctly
			installed.
		2.	Verify proper memory module type.
		3.	Remove and replace the identified
			faulty memory module(s).
		4.	If the error persists after replacing
			memory modules, replace the system
			board.
213-Incompatible Memory Module in	A memory module in memory socket	1.	Verify proper memory module type.
Memory Socket(s) X, X, ...	identified in the error message is missing	2.	Try another memory socket.
	critical SPD information, or is incompatible
	with the chipset.	3.	Replace DIMM with a module

conforming to the SPD standard.

214-DIMM Configuration Warning	Populated DIMM Configuration is not
	optimized.

Rearrange the DIMMs so that each channel has the same amount of memory.

184 Chapter 9 POST Error Messages