4.Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place.

Figure 7-21Installing a Drive into the 3.5-inch Drive Bay (Media Card Reader Shown)

5.Connect the appropriate drive cables:

a.If installing a second hard drive, connect the power cable and data cable to the rear of the drive and connect the other end of the data cable to the white connector on the system board labeled SATA1.

b.If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board labeled MEDIA.

Figure 7-22Connecting the Media Card Reader USB Cable

NOTE: Refer to System Board Connections on page 110 for an illustration of the system board drive connectors.

6.Replace the 5.25-inch drive.

7.Replace the front bezel (if removed) and access panel.

Drives 119