IBM DR550 manual Dual Node Zoning without Enhanced Remote Volume Mirroring

IBM System Storage DR550 Version 3.0 ------ 17 March 2006 Page 11

on the switch. These cables would also need to be connected to the customer network. You can then access the switch using the IP address. The Userid is ADMIN and the password is PASSWORD. You should change this password to confirm with site security guidelines.

If you should need to review the configuration or zoning within the switches, the IP address for switch 1 is 192.168.1.31 and switch 2 (only installed in dual node configurations) is 192.168.1.32. These addresses should not be changed. To gain access to the switches via the IP network, you will need to provide Ethernet cables and ports on your existing Ethernet network. Once the connections have been made, then you can connect to the IP address and use the management tools provided by the switch.

Dual Node Zoning – without Enhanced Remote Volume Mirroring

Engine1

Zone 1

Zone 2

Zone 3

DS4100_1

Slot 5 Slot 4 Slot 1 Slot 5 Slot 4 Slot 1 Engine2

	0		2	3							0		2	3						Zone 1
		1	2	3					7			1	2	3						Zone 2
					4		5	6							4		5	6		Zone 3
																			7
2005-B16_1										2005-B16_2
			Controller A1			Controller A2							Controller B1			Controller B2

DS4100_2 Controller A1 Controller A2 Controller B1 Controller B2

Note: Zone 3 is configured for use with the tape (TS1120, TS3310, 358x, 3592 with WORM cartridges are recommended) - ports 5-7 are connected to the tape drives

Dual Node Zoning – with Enhanced Remote Volume Mirroring

IBM Storage Systems Copyright © 2006 by International Business Machines Corporation