Integra RDC-7.1 instruction manual Index Parts and Facilities

Index Parts and Facilities—Continued

For further operational instructions, see the pages indicated in brackets [ ].

1Power switch [52]

Press to turn on and off the main power supply for the RDC-7.1. When the RDC-7.1 is turned on with the [Power] switch, the [Standby] indicator lights.

•Before turning on the power, check to make sure that all cords are properly connected.

•When the power is turned on, a sudden surge of current will occur that may adversely affect the operation of other devices. To prevent this, do not plug the RDC-7.1 into the same circuit used by sensitive equipment, e.g., computers.

2Standby/On button and On indicator [52]

If pressed with the [Power] switch turned on, the RDC-7.1 turns on and the display and [On] indicator light up. If pressed again, the RDC-7.1 returns to the standby state. In the standby state, the display and [On] indicator are turned off and the RDC-7.1 cannot be operated.

3Standby indicator [9, 52]

Lights when the RDC-7.1 is in the standby state and when a signal is received from the remote controller.

4Remote control sensor [9]

5Front display

6Master Volume dial [52]

Use to control the volume in the main zone. The volume for the remote zone (Zone 2 and Zone 3) is independent.

7Open/Close button

Press this button to open and close the front door that covers the lower buttons.

8Input source buttons and indicators (DVD, Video 1–7, Tape 1-2, Tuner, Phono, CD, and Net Audio) [52, 62, 65, 80]

Press these buttons to select the input source for the main zone. When an input source is selected, the indicator will light in blue.

To select the input source for the remote zone (Zone 2), first press the [Zone 2] button, and then the desired input source button.

To select the input source for the remote zone (Zone 3) or recording out (Rec Out), first press the [Rec/ Zone 3] button, and then the desired input source button.

9Zone 2 (GRN) and Rec/Zone 3 (RED) Indicator [70, 72]

For Zone 2, the indicator above the selected input source button will light green. For recording or Zone 3, it will light red. When the same input source is selected for Zone 2 and Rec/Zone 3, it will light orange.

0Pure Audio indicator [61]

Lights during pure audio playback.

Getting Started

11