Integra RDC-7.1 Connecting a Power Amplifier-Continued, Connecting the output terminal

Connecting a Power Amplifier—Continued

Connecting a Power Amplifier Using XLR Type Cables

You can connect the power amplifier that has XLR (balanced) type input terminals to the RDC-7.1 using XLR type cables. One XLR type input terminal set is available for this connection.

The pin assignments for these terminals, which conform to the AES* standard, are shown below.

Check the instruction manual that came with your power amplifier and verify that the input pin assignments are compatible with those for the RDC-7.1.

1.Connecting the output terminal

Match the pins and insert the terminal until you hear a “click.” Ensure that it is secure by gently pulling it.

*AES: Audio Engineering Society

2. Disconnecting the output terminal

XLR type Balanced cable

1. GND

2. non-inverting (+)

3. inverting (–)

Pull out the cable (in the direction indicated by the arrow) while holding down the connection cable button.

Push

RDC-7.1

S400

ETHERNET

(Net-Tune)

AUDIO

The i.LINK logo is a trademarks of Sony Corporation, registered in the U.S. and other countries.

						OUT
5	5	3	8	5	PB	Y

6	6		1		9		6			PR
										PB
1	1		2		4		1		3
		DIGITAL IN
		( BALANCED )								PR
2	2	AES/EBU	3		5		2		4
	OUT		R	L	OUT	R	L	OUT		OUT
							S VIDEO	VIDEO	VIDEO	S VIDEO

L

R

FRONT

CENTER

SUB WOOFER

SURR

(SINGLE)

L

R

SURR BACK (ASSIGNABLE)

	(ASSIGNABLE)						(ASSIGNABLE)
								L
								R
SUBWOOFER	SURR BACK R	SURR R	FRONT R	CENTER	FRONT L	SURR L	SURR BACK L	FRONT
PRE OUT A							(SINGLE)

Subwoofer

LINE INPUT

SURROUND BACK	SURROUND	FRONT	CENTER	FRONT	SURROUND	SURROUND BACK
RIGHT	RIGHT	RIGHT		LEFT	LEFT	LEFT
INPUT	INPUT	INPUT	INPUT	INPUT	INPUT	INPUT
SELECT	SELECT	SELECT	SELECT	SELECT	SELECT	SELECT

OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT OUTPUT

SPEAKER IMPEDANCE

4 OHMS MIN. PER EACH SPEAKER TERMINAL

FUSE	AC INLET	12V TRIGGER		SEVEN CHANNEL AMPLIFIER
		IN	OUT	MODEL NO. RDA-7.1

Power amplifier

26