Listening Mode Setup—Continued

b. Front Speaker

This option configures the front speakers to use when playing the source. Select the speakers you want to use. This setting can be made when the “(Speaker B) Front L/R” is set to “Main A” in the Speaker Configuration sub-menu.

A (Default): Outputs the source from the front speakers configured to “Speaker A.”

B:Outputs the source from the front speakers configured to “Speaker B.”

A+B: Outputs the source from the front speakers configured to “Speaker A” and “Speaker B.” Note that this option is not available when the front speakers are in Bi-amp configuration.

c. Center Speaker

This option configures the center speaker to use when playing the source. Select the speaker you want to use. This setting can be made when the “(Speaker B)

Center” is set to “Main A” in the Speaker Configuration sub-menu.

A (Default): Outputs the source from the center speaker configured to “Speaker A.”

B:Outputs the source from the center speaker configured to “Speaker B.”

A+B: Outputs the source from the center speakers configured to “Speaker A” and “Speaker B.”

d. Surr L/R Sp

This option configures the surround speakers to use when playing the source. Select the speakers you want to use. This setting can be made when the “(Speaker B) Surr L/R” is set to “Main A” in the Speaker Configuration sub-menu.

A (Default): Outputs the source from the surround speakers configured to “Speaker A.”

B:Outputs the source from the surround speakers configured to “Speaker B.”

A+B: Outputs the source from the surround speakers configured to “Speaker A” and “Speaker B.”

e. Subwoofer

This option configures the subwoofer to use when playing the source. Select the terminal to which the subwoofer you want to use is connected. This setting can be made when the “(Speaker A) Subwoofer” is set to an option other than “Not Used” in the Speaker Configuration sub-menu. However, when the “(Speaker

B)Subwoofer” is set to an option other than “Main A” in the Speaker Configuration sub-menu, the available options will be “A” or “Not Used.”

A (Default): Outputs the source only from the subwoofer connected to the SUBWOOFER PRE OUT A terminal.

B: Outputs the source only from the subwoofer connected to the SUBWOOFER PRE OUT B terminal.

A+B: Outputs the source from the subwoofers connected to the SUBWOOFER PRE OUT A and SUBWOOFER PRE OUT B terminals.

Not Used: No subwoofers are used for playback.

In Zone 2, you can set the following options.

a. Mode

This option allows you to configure the width of a virtual sound image which is simulated using two speakers while you use the Dolby Virtual Speaker effect.

Wide: The breadth of the sound image is emphasized.

Reference (Default): The general 5.1 ch surround sound is simulated.

b. Decode (2ch)

This option allows you to select the decode mode before the Dolby Virtual Speaker effect is applied.

Dolby Pro Logic II: The Dolby Virtual Speaker effect is applied after the signal is decoded with Dolby Pro Logic II.

DTS NEO:6: The Dolby Virtual Speaker effect is applied after the signal is decoded with DTS NEO:6.

Dolby Headphone Setup Sub-menu

This sub-menu allows you to enable/disable the Dolby Headphone function when you use the headphones.

a. Mode

On (Default): Enables the Dolby Headphone function.

Off: Disables the Dolby Headphone function.

118

Page 118
Image 118
Integra RDC-7.1 instruction manual 118, Dolby Headphone Setup Sub-menu, Mode, Decode 2ch