Integra RDC-7.1 Note for European models, Index Parts and Facilities—Continued, Getting Started

Index Parts and Facilities—Continued

COff [71]

When not using either Rec/Zone 3 or Zone 2, press that button and then press the [Off] button to turn off the signal.

If the Rec/Zone 3 or Zone 2 signal is turned on and the connected component is not turned on, the electric signal will still be sent through the circuitry and the excess load may cause deterioration of the audio signal.

DDisplay button [56]

Press to display information about the current input source signal. Each time you press the [Display] button, the screen changes to show you different information concerning the input signal.

E DSP [61]

Press these buttons to scroll through the listening modes and set a new one for the input source you are currently listening to. For each different input signal, different listening modes are possible. See page 58 for a detailed explanation of the different listening modes.

FDimmer button (Other than European models) [54]

Press to set the brightness of the front display. There are four settings available: normal, dark, very dark, and volume only.

For European models, this function can be operated only with the remote controller.

FRT/PTY/TP button (European models only) [65]

JMemory button [63]

Press to assign the radio station, to which you are currently tuned, as a preset channel or press to delete a previously preset station.

K Setup /[ ]/[ ]/Enter/[ ]/[ ]/Exit [90]

These buttons are used with the On Screen Display (OSD) menu.

Setup: Press to bring up the OSD menu.

Exit: Press to exit the OSD menu when at the Menu Screen, or move to one screen previous to the one that is displayed if at any other screen.

and : When selecting items in the OSD menu, press these buttons to move the on-screen cursor (or the highlighted portion) upward and downward.

and : When setting parameters in the OSD menu, press these buttons to select parameter values or modes.

Enter: Press to display the screen for the selected item in the OSD menu.

Note for European models:

These buttons are also used to set programs and finish scans when performing a PTY or TP scan with the RDS broadcasts.

LPhones jack [54]

This is a standard stereo jack for connecting stereo headphones.

Getting Started

This button is only available on European models. Press this button to tune into the Radio Data System (RDS) for FM broadcasting. RDS was developed within the European Broadcasting Union (EBU) and is available in most European countries. Each time the button is pressed, the display changes from RT (radio text) to PTY (program type) to TP (traffic program) and then back to RT again.

G Tuning button [62]

Use these buttons to change the tuner frequency. The tuner frequency is displayed in the front display and it can be changed in 50 kHz increments for FM and 9 kHz increments for AM. When a station is tuned into, “> <” will appear in the front display (When the stereo signal is received,

“ ” will appear).

H Preset button [63]

When AM or FM is selected as the input source, press one of these buttons to jump to a radio station that you preset using the [Memory] button. Pressing the right button moves from the most recently preset station to older ones, and pressing the left button moves in the reverse order.

ITuning Mode button [62, 63]

This button is used to select the Auto or Manual Tuning Mode.

13