Integra RDC-7.1 instruction manual Using the Remote Controller with Other Components, 129

Using the Remote Controller with Other Components

You can use the RDC-7.1’s remote controller (RC- 554M/555M) to control your other AV components, including those made by other manufacturers. To do this you can:

•Enter a remote control code for the component that you want to control (e.g., DVD, TV, VCR).

•Learn commands directly from the other component’s remote controller (see page 136).

•Use the Macro function to learn a sequence of actions (see page 137).

Entering a Remote Control Code

By entering the appropriate remote control code for each of your components, you can control each compo- nent by selecting the relevant remote controller mode: DVD, TV, VCR, CBL (cable), or SAT (satellite).

1	Look up the appropriate remote
	control code for the component.
	See “Remote Control Codes” on pages
	130-133.
2	Press and hold down the [Custom]
Custom	button for more than three sec-
	onds.
	The remote controller enters Custom
	mode.
3	Roll the scroll wheel to select
	“PRGRM,” and then press the
	scroll wheel.

4	Roll the scroll wheel to select the
	the remote controller mode you
	want to use with the component,
	and then press the scroll wheel.
	The following remote controller modes
	can be selected: DVD, TV, VCR, CBL,
	or SAT.

5	Use the number buttons to enter
	the 4-digit remote control code.

1 2 3

@.-'/ ABC DEF

4 5 6

GHI JKL MNO

7 8 9

PQRS TUV WXYZ

0

If the code is accepted, the following

appears on the display for a while, and then the normal display reappears.

		If the code is not accepted, after the
		message “RETRY” has been displayed,
		the code entry display reappears, and
		you should try entering the code again.
		To cancel this procedure at any point,
		press the [Custom] button.				Controller
6		Select the remote controller mode,
		point the remote controller at the
		component, and check its opera-
		tion.				Remote
		The remote controller buttons that can
		be used in DVD mode are shown on
		page 124. Those that can be used with				the
		the TV, VCR, CBL, and SAT modes are
		listed on pages 134 and 135.				Using
Remote Control Codes for an
IntegraRESEARCH/Onkyo DVD player
The remote control code that you use with an
IntegraRESEARCH/Onkyo DVD player depends on
whether it’s connected via			, as follows:
5001: Use this code if you’ve connected an					cable
and an RCA/phono analog audio connection cable to
your DVD player. This is the default setting, so if
you’re using		, you don’t need to change it. Point
the remote controller at the RDC-7.1 to operate the
DVD player.
5002: Use this code if your DVD player doesn’t have
an	socket, or you’re not using			. Point the

remote controller at the DVD player to operate it.

129