Integra RDC-7.1 instruction manual Lock/Version Setup, 123, Network Setup

Network Setup—Continued

Client Sub-menu

While the system sending information is called a server, the machine receiving the data is called a “client.” Multiple clients can be connected to a single server. From the viewpoint of Net-Tune Central, the RDC-7.1 is a client.

a. Client Name

Confirm the client name used on the Net-Tune system. The client name is assigned by the RDC-7.1. You cannot change the assigned name.

b. Wakeup on LAN

Specify the network condition on standby of the RDC-7.1.

Enable: To be left connected.

Disable: To be disconnected while the RDC-7.1 is on standby to save electricity.

c. NTSP Port

Specify the TCP/IP port to communicate with Net-Tune Central. This setting is to determine the port for intercommunication and needs to match the setting at Net-Tune Central. Do not change the port number unless absolutely necessary. Press the [ ]/[ ]/[ ]/ [ ] buttons to select numerics, and then press the [Enter] button. When all numerics are entered, exit from the character entry mode.

Note:

When the settings are complete, press the [Return] button to return to the Network Setup menu. Use the

[ ]/[ ] buttons to select “→ Save Settings,” and then press the [ ] button to save settings described in “Network Setup” on pages 122 and 123. After setting, saving data will take a few seconds. While saving data, be sure not to turn off the power, otherwise the data will be lost.

Specifications:

Ethernet port: 10BASE-T

File type: MP3, WMA, WAV

(supports non-compression format and sampling frequency of 32, 44.1, 48 kHz)

(WMA files with contents protected cannot be played)

Lock/Version Setup

The following sub-menus allow you to lock your settings or display the software version of the RDC-7.1.

Lock Setup Sub-menu

a. Lock

You can lock all of the setting menus to prevent settings from being changed by mistake.

Locked: Powering on and off will resume the setting when it was locked, discarding any modification that was made after locking.

Unlocked (Default): No lock on setting operations.

Firmware Version Sub-menu

This section deals with confirmation of the firmware version for each program currently installed in your RDC-7.1 (No procedure is provided for updating the firmware).

a. Master version

Confirm the firmware version for the main program.

b. i.LINK(IEEE1394) version

Confirm the firmware version for i.LINK. This item appears when the i.LINK(AUDIO) terminal board [A] is inserted.

c. Net-Tune version

Confirm the firmware version for the Net-Tune program. This item appears when the ETHERNET terminal board [B] (for Net Audio) is inserted.

d. HDMI version

Confirm the firmware version for HDMI. This item appears when the HDMI terminal board [L] is inserted.

Setup Menu

123