Integra RDC-7.1 Hardware Setup, Remote Control Setup Sub-menu, TV Format Sub-menu

Hardware Setup

In this section, you will perform the initial settings for the following scenarios.

•When you want to change the RDC-7.1’s remote control ID.

•When you want to fix the TV Format setting to PAL or NTSC.

•When you want to fix the AM Frequency Step setting to 9 kHz or 10 kHz.

Remote Control Setup Sub-menu

Remote ID

This section explains how to change the RDC-7.1’s remote control ID. You may need to change this if the RDC-7.1’s remote controller interferes with other IntegraRESEARCH components located in the same room. You can select 1, 2, or 3 for remote control ID. If you change the RDC-7.1’s remote control ID, be sure to select the same ID for the remote controller (See page 142). The default ID for both the RDC-7.1 and remote controller is 1.

Note:

It is recommended that you perform setup using the [Setup]/[]/[ ]/[ ]/[ ]/[Exit] buttons of the RDC-7.1’s front panel. If the remote controller is used for setup, signals from the remote controller will not be received just after the remote control ID settings have been changed (See “Changing the Remote Controller’s Control ID” on page 142 to change the remote control ID for the remote controller).

TV Format Sub-menu

TV Format (for all models other than USA and Canadian models)

The settings in the TV Format sub-menu can be configured for Main B and Zone 2 as well as for Main A. When you want to reconfigure the settings to conform to the television format used in the area where you use the RDC-7.1, use this sub-menu so that no time is wasted on detection.

Auto: This is the default setting. When you leave this setting unchanged, the television format is detected and automatically set by the RDC-7.1.

PAL: Use this setting when you know the television format is PAL.

NTSC: Use this setting when you know the television format is NTSC.

AM Frequency Setup Sub-menu (Asian and Australian Models Only)

Frequency Step

The setting in this sub-menu determines the incremental or decremental amount when adjusting the AM tuner frequency. The initial setting is 9 kHz, and this only needs to be changed if you are using the RDC-7.1 in a 10 kHz region.

9 kHz: Select if 9 kHz increments are used in your area.

10 kHz: Select if 10 kHz increments are used in your area.

Setup Menu

91