Chapter 6: Setting Up Calls

The Remote Access Setup dialog box reappears.

8.To quickly add and configure remaining channels as RAS ports with the same properties as a configured port, do the following:

a.Select the port whose properties you want to copy, and click the Clone button.

The next available channel is added to the port list. The port usage properties are copied from the selected port.

b.Click the Clone button repeatedly until you have configured all the RAS ports you need.

Or to configure the channels’ port usage properties one- by-one, click Add to display the Add RAS Device dialog box. Then repeat Steps 5 through 7.

9.When you have finished configuring RAS ports, on the Remote Access Setup dialog box, click Continue.

The Network Services dialog box reappears.

10.To make the settings take effect, click Close.

A message informs you that you must shut down and restart your computer before the settings take effect.

11.Continue as follows:

If the system is a basic Windows NT system, without the Windows NT Service Pack installed, click Yes to restart the computer.

If the Windows NT Service Pack is installed, click No. Then reinstall the Service Pack. (Service Pack 3 or higher is recommended.) Restart the system when prompted after you complete the Service Pack installation.

5536 PRI RAS Communications Controller Users Guide

93