Connecting to an MVIP Bus

Configuring MVIP Electrical Termination

If this is the last board in a multiple MVIP Bus configuration, it requires electrical termination in the MVIP Bus. To provide the required electrical termination, place two jumpers on the two 2-pin connectors located next to the MVIP connector.

Each jumper must be inserted perpendicular to the printed circuit board, as shown in the following figure:

Figure 2-5. Electrically Terminating the MVIP Bus

If the board does not need to be electrically terminated, do not place any jumpers on the 2-pin connectors.

24

Interphase Corporation