![](/images/backgrounds/146446/146446-244114x1.png)
Setting Up or Removing Channels as RAS Ports
Removing RAS Port Designations
If you need to remove a channel from the RAS device list, do the following:
1.Access the Remote Access Setup dialog box, as described in Steps 1 through 3 of Setting Up RAS Port Designations on page 90.
2.Select the channel in the list on the Remote Access Setup dialog box, and click Remove.
3.When you have finished removing RAS ports, on the Remote Access Setup dialog box, click Continue.
The Network Services dialog box appears.
4.To make the settings take effect, click Close.
A message informs you that you must shut down and restart your computer before the settings take effect.
5.Continue as follows:
–If the system is a basic Windows NT system, without the Windows NT Service Pack installed, click Yes to restart the computer.
–If the Windows NT Service Pack is installed, click No. Then reinstall the Service Pack. (Service Pack 3 or higher is recommended.) Restart the system when prompted after you complete the Service Pack installation.
94 | Interphase Corporation |