![](/images/backgrounds/146446/146446-24495x1.png)
|
| Chapter 5: Setting Up WAN Firmware and Hardware |
|
| |
| Use the following buttons to set up firmware information: | |
|
| |
Click... | To do this... | |
|
| |
Load | Download the current firmware to the selected card. | |
| CAUTION: This option disconnects all current RAS- | |
| connected users and disables the RAS Server. After a | |
| firmware download, the RAS Server must be | |
| by being stopped and restarted, as follows: | |
| 1. | From the Start menu, select Settings, and then Control |
|
| Panel. Then |
|
| Services dialog box. |
| 2. | Select Remote Access Server from the list of services, |
|
| and click Stop. |
| 3. | When a message informs you that the RAS Port Manager |
|
| will also be stopped, click OK. |
|
| A message informs you that RAS is being stopped. |
| 4. | To restart the RAS Server, select Remote Access Server |
|
| and click Start. |
| 5. | Select Virtual Motion RAS Port Manager and click |
|
| Start. |
|
| |
New | Set alternate firmware as the current firmware. | |
|
|
|
NOTES
The Properties button in the Firmware section is disabled because this product has no configurable layers.
If you load firmware, save changes and restart the system as described in Saving WAN Setup Properties on page 87.
5536 PRI RAS Communications Controller Users Guide | 75 |