Chapter 4: Installing the Software

This dialog box enables you to set up 5536 firmware and hardware. The board name is displayed in the Cards section.

NOTE

If the Cards list is empty, the board might not be properly installed. See Problems and Possible Solutions on page 123 for information about correcting the problem.

Use the Cards section to do the following tasks:

If your board is connected to an MVIP Bus, enable the MVIP bus connection.

Set up ISDN port properties.

Configure ISDN port properties for both ISDN and Digital Modem RAS Support drivers.

If you plan to install the Digital Modem RAS Support driver, set up digital modem port properties. Set up digital modem and ISDN port properties at this point (regardless of which driver you selected first).

Enabling the MVIP Bus Connection

If your board is connected to an MVIP Bus, enable the Bus connection as follows:

1.In the Cards section of the WAN Adapters Setup dialog box, select the board and click the Properties button.

5536 PRI RAS Communications Controller Users Guide

45