Minimum System Requirements

If the ACE/Server grants the access, the communication can continue with the Windows NT authentication phase.

If the ACE/Server refuses the access, the communication is immediately broken. When the connection is untrusted because of the passcode end-of- delay, the remote client is not especially notified: the failure is a connection failure. It is the client’s responsibility to start the connection again.

The RAS support driver can manage secured multilink connections as well. The SecurID authentication is processed only for the primary link.

All the SecurID authentication successes or failures are registered in the Windows NT Event log.

Minimum System Requirements

Following are the minimum system requirements for using this board with Microsoft Remote Access Service (RAS):

Intel® system running Windows NT Version 4.0

PCI Bus architecture conforming to PCI Local Bus Specification Revision 2.1

Pentium processor at 133 MHz or faster

64 MB RAM (possibly 128 MB or more, depending on your RAS configuration and usage)

Hard disk with 6 MB free

CD-ROM drive

Single PRI version: One functional ISDN primary rate interface for each board

Dual PRI version: One or two functional ISDN primary rate interfaces for each board

12

Interphase Corporation