Completing the Software Installation

In addition, you may need to do one or all of the following, depending on your board and system configuration:

If your board is connected to an MVIP Bus, the MVIP Bus connection must be enabled so the software recognizes the Bus connection. If you need to enable or disable the Bus connection, see Setting Up Card Properties on page 77.

If you need to activate the internal CSU included on the board, see Editing DS1 Properties on page 82.

Upon completion of the software installation, eight Serial driver COM ports are automatically assigned to the board’s digital modems. If you need to change the number of COM ports assigned to the digital modems, see Setting Up Card Properties on page 77.

If you need to change other firmware, card, or port properties, see Setting Up WAN Firmware and Hardware on page 71.

If you need to change call setup properties for ISDN RAS support calls, digital modem RAS support calls, or digital modem serial driver calls, see Setting Up Calls on page 89.

If you need to ensure that applications that use Serial driver COM ports under Windows NT can detect the board’s digital modems, see Managing Serial Driver COM Ports on page 109.

For an overview of using the board in the RAS environment, see Index of Common Tasks on page 177. For detailed information about RAS Server or RAS Dial-Up Networking, see Microsoft RAS online help.

64

Interphase Corporation