![](/images/backgrounds/146446/146446-244201x1.png)
|
| Appendix F: Quick Reference of Common Tasks |
|
| |
|
| |
If you want to... | Do this... | |
|
|
|
Open the Remote | 1. | From the Start menu, select Settings, and then |
Access Setup dialog |
| Control Panel. |
box | 2. | |
| ||
|
| Services tab to display the Services dialog box: |
| 3. | From the Network Services list, select Remote |
|
| Access Service, and then click Properties. |
|
| Figure |
Bind a protocol to | 1. | Open the Remote Access Setup dialog box. (See |
an ISDN or Digital |
| |
Modem RAS Port |
| click Network. |
|
| NetBEUI, IPX/SPX, and TCP/IP protocols are |
|
| available. RAS allows you to configure them |
|
| differently depending on the connection type: dial- |
|
| in or |
| 2. | Select the protocol(s) you want to bind to the |
|
| board. |
| NOTE: The more protocols you bind, the more | |
| memory RAS uses. | |
|
|
|
Configure a RAS | 1. | Open the Remote Access Setup dialog box. (See |
port to accept |
| |
incoming calls |
| select the port and click Configure. |
| 2. | Select either the Receive calls only or the Dial out |
|
| and Receive calls option, and click OK. |
5536 PRI RAS Communications Controller Users Guide | 181 |