Menu Display and Detailed Settings

AGC Mode

For setting whether to link the limiter operation of [CH1] and [CH2].

Select “Link” to link or “Separate” to separate. [Setting Values: Link, RSeparate]

Memo :

Enabled only when both the [AUX] input terminal and [INPUT1/INPUT2] input terminal are set to “LINE” or “MIC”, and CH1/CH2 of the [CH1/CH2 AUTO/MANUAL] switch is set to “AUTO”.

XLR Manual Level

For setting whether to link manual audio adjustment operation between [INPUT1] and [INPUT2] terminals.

Select “Link” to link or “Separate” to separate. When this item is set to “Link”, adjust the recording level using the [CH1] recording level adjustment knob.

[Setting Values: Link, RSeparate] Memo :

Enabled only when both the [INPUT1/INPUT2] input terminals are set to “LINE” or “MIC”, and both [CH1]/[CH2] of the [CH1/CH2 AUTO/ MANUAL] selection switches are set to “MANUAL”.

When this item is set to “Link”, [CH2] recording level adjustment knob is disabled.

Int. Mic Separation

For setting the enhancement level of the stereo effect of the built­in microphone.

 1 to 4:

Enhances the stereo effect. Increasing the value increases the stereo effect.

 Effect off:

Does not enhance the stereo effect.  Mono:

Sets the built­in microphone to monaural. [Setting Values: 1 to 4, Effect off, Mono (R2)] Memo :

When any value from 1 to 4 is selected, the sound quality changes slightly due to the process of enhancing the stereo effect. This is normal.

This menu is enabled when the [CH1]/[CH2] selection switch is set to “INT”.

Test Tone

For specifying whether to output the audio test signals (1 kHz) during color bar output. [Setting Values: On, ROff]

INPUT1/2 Wind Cut

For selecting whether to cut the low frequencies of the audio input signals (low­cut) when the [INPUT1/ INPUT2] switch is set to “MIC” or “MIC+48V”.

Set this item to reduce wind noise from the microphone.

 Both:

Enables low­cut on both the [INPUT1] and [INPUT2] terminals.

 INPUT2:

Enables low­cut on the audio of the [INPUT2] terminal only.

 INPUT1:

Enables low­cut on the audio of the [INPUT1] terminal only.

 Off:

Disables low­cut.

[Setting Values: Both, INPUT2, INPUT1, ROff]

Int. Mic Wind Cut

For selecting whether to cut the low frequencies of the audio input signals (low­cut) from the built­in microphone. Set this item to “On” to reduce wind noise from the microphone.

[Setting Values: On, ROff]

Equalizer

You can correct the characteristic and enhance the sound of the connected microphone using this equalizer setting.

For setting the audio frequency from a 5­band equalizer.

 Frequency:

100Hz, 330Hz, 1kHz, 3.3kHz, 10kHz  Variable level:

± 6dB (1dB step)

Memo :

Audio will be recorded in the characteristic set in the equalizer.

Set all bands to “0dB” to bypass the equalizer.

When the equalizer level is set to +side, the audio may be distorted. In this case, reduce the recording level in Manual mode.

If the values of multiple frequencies are changed, the specified levels and the actual levels may be different due to interference between the frequency bands.

This function is enabled only when both [INPUT1/2 Wind Cut] and [Int. Mic Wind Cut] are set to “Off”.

108

Page 108
Image 108
JVC GY-HM650U specifications 108