Using AC Power (DC IN Power)
Use the supplied AC adapter to operate the camera recorder with AC power.
Preparations | 2 | POWER |
| |
ON | 1 | |||
| ||||
|
|
| ||
|
| OFF |
| |
|
| (CHG) |
| |
|
| MODE |
|
.
1Connect the DC cable of the AC adapter to the [DC] terminal of the camera recorder.
Check that the power switch of the camera recorder is set to “OFF(CHG)”.
Open the cover of the [DC] terminal and connect as shown in the diagram.
2Hold down the lock button (blue) at the center of the [POWER ON/OFF(CHG)] switch to set to “ON”.
Power will be supplied to the camera recorder.
Caution :
Power Status Display
Viewfinder Screen and LCD Monitor
The power status is displayed on the display and menu screens.
Display |
| Description | |
)7.4V | Currently powered by a battery. | ||
)100min | When the battery power runs out, | ||
430% | the battery mark appears hollow, | ||
& | and “RES” (yellow) is displayed. | ||
|
| Memo : |
|
|
|
| |
|
| You can set the display using | |
|
| ||
|
| ||
|
| ( P105 [ Battery ] ) | |
|
|
| |
| Currently powered by an AC | ||
|
| adapter. | |
Memo : |
|
|
|
|
|
|
If the supplied battery (or equivalent battery sold separately) is not used, the battery mark which indicates the battery level may not appear.
Display Screen
( | P120 | [Display Screen in Camera Mode] ) |
( | P125 | [Display Screen in Media Mode] ) |
Do not insert or remove the DC cable during recording.
Do not use power supply of high voltage fluctuation, containing noise such as ripple, or with insufficient capacity.
Charging the BuiltIn Battery
282min
100min
1920x1080
60 i HQ
4030 | 20 |
.
00: 00: 00.00
Jan 24 , 2012 12 :34 : 56
|
|
|
| 5 . 6f t | |
|
|
| ND 1 /64 | ||
|
|
|
| AE+6 | |
|
|
|
| 0dB | |
10 | 0 |
|
| F1. 6 | |
P13000K | 1 / 100 | ||||
|
|
The date/time and time code data are stored using the builtin rechargeable battery.
When power is connected to the camera recorder, the builtin battery always gets charged. When the power is disconnected, the battery gradually discharges.
The battery will be totally discharged if left unused for 3 months and the date/time and time code data will be reset. When this happens, set the [POWER ON/OFF(CHG)] switch to “ON” to display the [Initial Setting] screen, then set the
date/time.
( P32 [Initial Settings] )
Menu Screen
( P92 [Display and Description of the Menu Screen] )
.
30