Setting Time Code without Opening the Menu
MENU/THUMB
CANCEL
MENU/THUMB | AE LEVEL |
|
Shooting | FOCUS ASSIST/1 | OIS / 2 |
CANCEL |
| |
| TIME CODE |
|
| . |
|
| Memo : |
|
Settings cannot be made in the following cases.
Menu screen is displayed.
The camera recorder is not in the Camera mode.
Setting Time Code
1Set
( P102 [ TC Generator ] )
2Hold down the [MENU] button and press the [FOCUS ASSIST/1] button.
The [TC Preset] setting screen appears.
Cursor
During drop frame
During
.
3Set the time code (hour, minute, second, frame).
Use the crossshaped button (HI) to place the cursor at the item to set, then use the cross shaped button (JK) to change the values.
Memo :
Press the [OIS/2] button to reset each digit to “0”. The cursor moves to the time digit (left).
4Check the values and press the Set button (R).
The time code is set and the screen returns to the normal screen.
To cancel the setting, press the [CANCEL] button.
Caution :
When the camera recorder is switched to Media mode during editing, editing will be canceled and the screen will close.
When editing the time code, operation of the [FOCUS ASSIST/1] and [OIS/2] buttons that are configured in [Main
button.
( P97 [User Switch Set Item] )
Recording Time Code in Continuation of the Recorded Time Code on SD Card
This camera recorder is equipped with the time code reader.
1Set [TC/UB]-[TC Generator] to “Regen”.
When the camera recorder enters from recording standby mode to recording mode, it reads the time code already recorded on the SD card and records the new time code in continuation of that value.
The same data as the user’s bit already recorded on the SD card is recorded.
Memo :
When
instead of the clip settings. ( P102 [ Drop Frame ] )
66
