Camera Function Menu
Menu screen for specifying operation settings during shooting.
This item can only be selected in the Camera mode.
Bars
For setting whether to output color bars. [Setting Values: On, ROff]
Memo :
The audio test signals (1 kHz) can be output simultaneously with the color bar output.
( P108 [ Test Tone ] )
OIS
For setting whether to enable image stabilizer. When “On” is selected, set the Level.
[Setting Values: On, ROff]
Level
For setting the level of the image stabilizer. [Setting Values: High, RNormal]
Memo :
When “High” is selected, correcting severe camera shake may cause the area surrounding the image to darken.
Flicker Correction
For setting whether to adjust image flicker that occurs under a fluorescent light.
[Setting Values: On, ROff]
Flash Band Correction
For reducing the condition of the flash band phenomenon, which creates an unnatural image with a part of it brightly lit, such as by the camera flash of another still camera.
[Setting Values: On, ROff]
Caution :
Flash band correction function is not available in | |
any of the following cases. | |
When [Rec Mode] is set to “Variable Frame” | |
When [Frame & Bit Rate]/[3Frame & Bit | |
| Rate] is set to “24p(HQ)” or “24p(UHQ)” |
When in the Automatic Shutter mode or when | |
| the shutter is turned on in the Manual Shutter |
( | mode |
P54 [Manual Shutter Mode (Manual Shutter | |
Switching)] ) | |
When [Network] is set to “On(SDI Off)” or | |
“On(HDMI Off)”
[Flash Band Correction] operates when the luminance of the screen varies widely, with or without flash light. However, depending on the shooting condition, the flash band correction may not be fully effective even if there are flash lights.
The following symptoms may occur under flash light, but these are not malfunctions due to flash band correction.
Moving object appears to be stationary momentarily.
A horizontal line appears on the images.
The [Flash Band Correction] function will be set to “Off” if the camera recorder switches from the Camera mode to another mode, or when the [POWER ON/OFF(CHG)] switch is set to “OFF(CHG)”.
Shutter
For specifying shutterrelated settings.
Use this item to set to “Step” (fixed value) or “Variable” when operating with the crossshaped button (JK) on the right side.
Variable:
Sets to variable scan. Use this setting such as when shooting a PC monitor.
Step:
Sets to step shutter, which switches the shutter speed by a fixed value.
[Setting Values: Variable, RStep]
AE Level
For setting the convergence level during AE (Auto Exposure).
This can also be adjusted using the crossshaped button (HI) on the right side.
[Setting Values: 6 to +6 (R0)]
AE Speed
For setting the convergence speed during AE (Auto Exposure).
[Setting Values: RFast, Middle, Slow]
Menu Display and Detailed Settings
95
