Press equally on both sides.

4Check the installation.

Turn on the power of the D1200, and verify that the CDRW-1 is detected in the startup LCD screen.

If the CDRW-1 was detected

3. Inserting a disc

Make sure that the D1200 is powered-on.

1Open the disc tray.

Press the eject button of the CDRW-1to open the disc tray.

At this time the tray will only open halfway. Manually pull out the tray far enough that the disc can be placed on the tray.

Eject button

When you use the CDRW-1for the first time, remove the pickup stopper from the disc tray before using the drive.

2Place the disc on the tray.

Place the disc accurately on the tray with the label facing upward.

3Close the disc tray.

Push the disk tray in until it is completely closed.

If the D1200 does not recognize the disc, re-install the CDRW-1 as described in “Installing the CDRW-1.”

If the CDRW-1 was not detected

If the D1200 does not detect the D1200, try pressing strongly once again on the areas indicated by the arrows in step 3, or re-install the CDRW-1.

To remove the CDRW-1

Slice the [EJECT] switch located on the bottom panel of the D1200, and the CDRW-1 will be ejected from the D1200. Gently pull out the ejected CDRW-1.

This procedure must be performed with the power off.

To fasten the CDRW-1 in place

By using the screw that is included with the CDRW-1, you can lock the [EJECT] switch of the D1200 to ensure that the CDRW-1 does not come out accidentally.

4. Removing a disc

1Press the eject button to open the disc tray.

2Gently remove the disc from the disc tray.

3Push the disc tray in until it is completely closed.

Emergency disc removal

Normally you will be able to remove the disc as described above. However if this is not possible due to a power failure or other problem, you can also remove the disc as follows.

To use this method, you will need a pin-like object of less than 2 mm diameter, such as a straightened paper clip. Insert this straight into the manual eject hole, and push. The disc tray will be forced open.

Excessive use of this method may cause the CDRW-1to malfunction.

This procedure must be performed with the power off.

Manual eject hole

150