Operation

If you want to edit the effect in greater detail and save it

1Edit the effect in Modeling mode (→ p.45).

2Access the [INSERT] “InsEff1” tab page. The [MODELING] key will go dark.

The display will show the insert effect program that you had been editing as a modeling effect.

3Edit the settings as an insert effect, and save.

Refer to “To edit an effect” (→ p.43) and “To save the effect program” (→ p.44).

For details on using an effect program that you saved, refer to “1. Using insert effects” (→ p.42).

To exit Modeling mode

To exit Modeling mode, press the [NO/CANCEL] key several times to make the [MODELING] key go dark.

To restore the factory settings

Press the “ ” button, and the selected modeling effect will return to the factory settings.

5. Operation in Modeling mode

Limitations in Modeling mode

•The last-used modeling effect settings will be restored.

When you exit Modeling mode

•The [MODELING] key will go dark.

•With the exception of tracks whose [TRACK STA- TUS] is set to REC, the audio input settings to the mixer will return to the state prior to when you entered Modeling mode.

When you change the track status

If you change the [TRACK STATUS] while in Modeling mode, the “InsertTo” setting of the insert effect will change as follows.

•If you make settings for monaural recording by set- ting only one [TRACK STATUS] to REC, the

“InsertTo” setting will change to “In1→ 1→ upper line (the track set to [REC]) lower (off)”.

•If you make settings for stereo recording by setting

two [TRACK STATUS] key to REC, the “InsertTo” setting will change to “In1→ 1→ upper line (the track set to [REC]) lower line (the track set to REC +1)”.

•If you have not set [TRACK STATUS] to REC, the “InsertTo” setting will not change.

•Only the [INPUT 1] or [GUITAR IN] jacks can be used.

•The [INPUT/OUTPUT/SOLO] “Ch1–6” and “Ch7– 12” tab pages will be displayed as follows, and you cannot make Input settings in Modeling mode.

•A maximum of two tracks can be recorded simulta- neously.

•If you play back a scene or switch scenes while in Modeling mode, the insert effect settings registered in that scene will not be reflected.

•You cannot set [TRACK STATUS] to INPUT (orange).

5-1. Internal operation in Modeling mode

In Modeling mode, various functions will be set automatically in the following cases.

When you enter Modeling mode

•The [MODELING] key will light.

•All current assignments in the [INPUT/OUTPUT/ SOLO] “Ch1–6” and “Ch7–12” tab pages will be memorized, the “DigiIn” button will be turned off, and all input channel settings will be set to “1.” “SubIn” will be muted.

•The [BOUNCE] “RecMode” tab page “RecMode” will be set to “Input.”

•[TRACK STATUS] for track 1 and track 2 will be set to REC, and the remaining tracks will be set to PLAY.

•In the [INSERT EFFECT] “InsAss” tab page, the insert effect assignment will be set to “Input(In),” and the effect type will be set to “1in2outx2.”

“InsertTo” will be set to In1→ 1→ upper line (1) lower line (2).

• The insert effect 1 program will be changed.

47