(COUNTER)MODELING

Counter: Counter display

The counter in the upper right of each page indicates the current location in the song.

This lets you apply an effect to a guitar, bass or mic connected to the [GUITAR IN] jack or [INPUT 1] jack, and begin re- cording.

Category: Select an effect category

1

1. Select TimeDisp Type .........................................

Select the “” button to open the “Select TimeDisp Type” dialog box. Select the type of counter to be shown in the display, and press the [YES/OK] key.

1. Select Modeling Effect Category ........................[Guitar, Bass, Mic]

Selects either guitar, bass, or mic as the type of modeling effect to be used.

Move the cursor to the desired category and press the [ENTER] key. The effects of the selected category will appear, and you will enter Modeling mode.

MBT

MSM

MSF

FreeTime

__.__.__ (MBT): The current location will be shown as the number of measures from the beginning of the song.

From the left, the values indicate Measures, Beats, and Ticks (1/96th beat).

__:__.__ (MSM): The current location will be shown as the absolute time from the beginning of the song. From the left, the values indicate Minutes, Seconds, and Milliseconds (1/1000th second).

__:__.__F (MSF): The current location will be shown as the absolute time and number of frames from the beginning of the song. You will normally use this when synchronizing with MTC.

From the left, the values indicate Minutes, Seconds, and Frames (1/30th second).

__.__Free (FreeTime): The remaining available recording time on the hard disk will be shown.

From the left, the values indicates Minutes and Seconds, or Minutes.

To change the current time location, move the cursor to a counter value and use the [VALUE] dial to change the value. (→ p.32)

If the counter display is set to “Free,” the time will be

displayed as absolute time (MSM) in the STORE, MARK, SCENE, A.PUNCH, LOOP, and SCRUB pages.

Modeling 1

As an example, here are the settings that will appear if you select a Guitar modeling effect.

5

1

234

1. Exit...................................................................

Return to the effect category select screen, and exit Modeling mode. (The [MODELING] key LED will go dark.)

2. Select DRIVE....................................

[(*10 types)]

*TubeOD, ClassicDist, FatDist, MetalDist, Seattle, Big- Fuzz, TopBoost, US-HiGain, BritStack, Direct Selects the type of distortion.

Turn the knob located below “DRIVE” to select the desired type. You can also select the type by moving the cursor to “DRIVE” and turning the [VALUE] dial.

3. Select Tube Type ...............................

[000...100]

Adjusts the vacuum tube character. Turn the knob located below “TONE” to make adjustments. You can also adjust the character by moving the cursor to “TONE” and turning the [VALUE] dial.

4. Select CABINET ...............................

[(*12 types)]

*1x8Tweed, 1x12Tweed, 1x12Black.P, 1x12AC15, 2x12Black.P, 2x12AC30, 2x12ClassicA, 4x10Tweed, 4x12Classic, 4x12Vintage, 4x12Modern, FullRange Selects the type of cabinet.

Turn the knob located below “CABINET” to select the desired type.

84