of the sound that precedes the actual start of recording will also be recorded.

This is not valid at the beginning of the song. Also, if you use trigger recording to continue recording after the end of a previously-recorded track, a PreTrigTime setting other than “000 ms” will cause the corresponding length of the previously-recorded sound to be lost.

SCRUB

Here you can switch the Scrub, Play From/Play To, and Slow Play functions on/off.

The setting will alternate between On/Off each time you press the [SCRUB] key.

By using these functions, you can set Locate or Mark times easily and precisely while viewing the waveform.

1

2

3

The following functions will be available when the [SCRUB] key is on (LED lit).

Scrub function: Turn the [VALUE] dial to play back the track data.

Use this to find a specific location in the song while you listen to the sound. This method is similar to manually rotating an analog record on a turntable while you listen to the sound to find a desired location.

Play From function: When you press the [PLAY] key, playback will begin from the location at which you are currently stopped, and will continue for two seconds.

Then playback will stop, and you will return to the loca- tion at which playback began.

Play To function: When you hold down the [STOP] key and press the [PLAY] key, playback will begin from a location two seconds earlier than where you are cur- rently stopped, and will continue to that location.

By using the Play From function in conjunction with the Play To function, you can find a time location with greater accuracy.

Slow Play function: When you press the [FF] key, half- speed playback will begin from the location at which you are currently stopped. Press the [STOP] key to stop playback and return to the previous location.

The sound will play slowly, at a pitch one octave lower than normal. You can use this function by itself or in conjunction with a pitch shifter to learn difficult or rapidly -played phrases.

When this is “On,” the [VALUE] dial is used only for Scrub playback, and cannot be used to set parameter values.

1. Loc (Locate) ................................

[000:00.000...]

Changes the current time location.

You can turn the [VALUE] dial to move the location while listening to the sound and viewing the waveform.

2. TrackSelect.........................................

[Trk1...12]

Selects the track that will be played and whose waveform will be displayed.

You can also press the “ ” button and choose from the list.

3. Zoom In/Out/Up/Down

Adjusts the size of the waveform display and the playback speed:

: Expands the waveform display vertically.

: Shrinks the waveform display vertically.

: Expands the waveform display horizontally. : Shrinks the waveform display horizontally.

124