Reference

LOOP

 

TRIGGER

 

 

 

Loop: Settings for loop playback and recording

You can repeatedly play or record over the region specified by the [IN/LOC1] and [OUT/LOC2] times.

1

4

23

1. Loop ....................................................

[On, Off]

Turns loop playback on/off.

On: When you play back, the IN– OUT region will be played back repeatedly. If this is “On,” the [LOOP] key will light.

Off: Playback will occur normally.

Trigger recording is a function that automatically starts (triggers) recording when the volume of the input signal exceeds the threshold level.

Trigger: Settings for trigger recording

1

23

Trigger on

Threshold

PreTriggerTime

COUNTER

 

 

MODELING

 

INSERT EFFECT

 

 

EQ

 

 

MASTER EFFECT/ AUX SEND

 

FINAL EFFECT

 

 

BOUNCE

 

 

CD

 

2. In ..............................................

(000:00.000...)

Indicates the beginning of the loop.

You can set this time by using the [STORE] key and [IN/ LOC1] key, or by using the “Wave” display.

3. Out............................................

(000:00.000...)

Indicates the end of the loop.

You can set this time by using the [STORE] key and [OUT/LOC2] key, or by using the “Wave” display.

4. Wave................................................................

Displays the waveform.

By setting the IN and OUT times while you view the waveform, you can make settings more precisely.

(→ p.109)

 

Record-start time

1. TriggerRec

........................................... [On, Off]

Switches the trigger recording function on/off.

On: When in record-ready mode, recording will begin when the input signal exceeds the threshold level. If this is “On,” the [TRIGGER] key will light. Turn “TriggerRec” “On,” and then press the [REC] key (LED blinking) to enter record-ready mode. When the input signal to a channel whose [TRACK STATUS] key is set to record exceeds the threshold level, recording will begin automatically.

Off: Trigger recording will not occur.

Even if this is turned “On,” recording will not begin if the input level does not exceed the threshold level while in record-ready mode.

In this case, press the [STOP] key or [REC] key to cancel record-ready mode, and then adjust the “Threshold” setting.

2. Threshold.........................................

[000...100]

Specifies the threshold level for the input signal at which recording will be triggered when the trigger recording function is used. Recording will begin when the input level exceeds this setting.

Normally you should set this as low as possible without allowing recording to be triggered by noise. The appropriate level will depend on the input source. Re-adjust this setting if recording begins too early or too late.

3. PreTrigTime ..................................

[000...700ms]

Specifies the length of sound prior to the record-start time that will be captured when using trigger recording. Trigger recording will start recording when the input signal exceeds the “Threshold” level, but depending on the threshold setting and on the type of source, the initial attack of the first note may be lost. In such cases, you can set the “PreTrigTime” so that the lower-level portion

TUNER

 

 

RHYTHM

 

 

INPUT/ OUTPUT/ SOLO

 

 

SYSTEM/ USB

 

 

TRACK

 

 

SONG

 

 

IN/LOC1, …END/LOC4

 

 

MARK

 

 

SCENE

 

 

AUTO PUNCH

 

 

LOOP

 

 

TRIGGER

 

 

SCRUB

 

 

METER/ TRACK VIEW

 

UNDO

 

123