BOUNCE

RecMode: Select the recording mode

1

1. Select RecMode...........................

[Input, Bounce]

Selects the recording mode.

Input: Normal recording. The input (analog, digital, internal rhythm pattern, CD-R/RW drive) will be recorded. The channel faders will adjust the recording level of each track.

Bounce: Bounce-recording. The master LR bus will be recorded. The channel faders will adjust the playback level of each track, and the master fader, final effect will adjust the recording level.

If you select “Bounce,” two tracks will always be recorded simultaneously.

Bounce: Parameters for bounce- recording

For the bounce-recording procedure, refer to p.28, 29, 64.

2. RecordVirtualTrack ......................

[Current, a...h]

Selects the virtual track on which recording will occur. This setting specifies which virtual track (of the recording tracks selected by the [TRACK STATUS] key) will be used for bounce-recording.

Current: The currently selected virtual track will be used for recording.

a...h: The specified virtual track will be used for record- ing. By using a virtual track “a”–“h” other that “Cur- rent,” you can bounce-record to two virtual tracks without erasing any of the tracks 1–12.

However if the virtual track you select here is the same as the virtual track that has already been selected in [TRACK] “Vtr1–6” or “Vtr7–12,” the result will be the same as if you had selected “Current.”

To avoid accidentally recording over a track that has al-

ready been recorded, you should use the [TRACK] “Vtr1–6” and “Vtr7–12” tab pages to check on the virtual tracks that are currently selected and to see which virtual tracks already contain data.

12

1.Select BounceMode ....[10Tr+2In→ 2Tr, 12Tr→ 2Tr]

Specifies the bounce-recording mode.

10Tr+2In→ 2Tr: Select this when you want to combine ten tracks of playback with two inputs, and record the combined result on two tracks.

The input signals you specify in the [INPUT/OUTPUT/ SOLO] “Ch1–6” tab page and “Ch7–12” tab page will be valid for channels whose [TRACK STATUS] keys you set to REC (LED lit red), and will be recorded together with the playback tracks.

12Tr→ 2Tr: Select this when you want to combine twelve tracks of playback and record the result on two tracks. The track playback for channels whose [TRACK STA- TUS] key is set to REC (LED lit red) will also be valid, and will be recorded along with the other playback tracks.

You can apply a master effect to multiple tracks as you combine them to two tracks. When creating an audio CD, perform bounce-recording as a mastering opera- tion.

If you turn “Rhythm” “On” while using bounce-record- ing, the rhythm will also be recorded. (→ p.48)

92