|
|
|
|
| Effect Parameter List |
| |
|
|
|
|
|
|
|
|
|
| LEQG (Pre HEQ Gain [dB]) | +15dB | Sets the gain of High EQ |
| ||
|
| ||||||
Effects within |
| ||||||
| HEQG (Pre LEQ Gain [dB]) | ...+15dB | Sets the gain of Low EQ |
| |||
|
|
| |||||
| Level (Output Level)............................ | 0...100 | Sets the output level of the compressor |
| |||
|
|
|
|
|
|
| |
|
|
|
|
|
|
| |
Here are explanations of the parameters of each effect in the
P4EQ (Parametric 4band EQ)
Fc1 (Band1 Cutoff [Hz]) | ........... 20Hz... | 1.0kHz | Sets the center frequency of Band 1 | ||
Q1 | (Q) ............................................. | 0.5... | 10.0 | Sets the bandwidth of Band 1 | |
G1 | (Gain [dB]) ............................ | +18dB | Sets the gain of Band 1 | ||
Fc2 (Band2 Cutoff [Hz]) | ........... 50Hz... | 5.0kHz | Sets the center frequency of Band 2 | ||
Q2 | (Q) ............................................. | 0.5... | 10.0 | Sets the bandwidth of Band 2 | |
G2 | (Gain [dB]) ............................ | +18dB | Sets the gain of Band 2 | ||
Fc3 (Band3 Cutoff [Hz]) | ....... 300Hz... | 10.0kHz | Sets the center frequency of Band 3 | ||
Q3 | (Q) ............................................. | 0.5... | 10.0 | Sets the bandwidth of Band 3 | |
G3 | (Gain [dB]) ............................ | +18dB | Sets the gain of Band 3 | ||
Fc4 (Band4 Cutoff [Hz]) | ....... 500Hz... | 20.0kHz | Sets the center frequency of Band 4 | ||
Q4 | (Q) ............................................. | 0.5... | 10.0 | Sets the bandwidth of Band 4 | |
Gain4 (Gain [dB]) ....................... | +18dB | Sets the gain of Band 4 | |||
Trim (Trim) ........................................... | 0... | 100 | Sets the parametric EQ input level | ||
|
|
|
|
|
|
Excit1 (Exciter1)
Blend (Exciter Blend)................... | +100 | Sets the intensity (depth) of the Exciter | |
|
|
| effect |
Empha (Emphatic Point)...................... | 0... | 140 | Sets the frequency range to be empha- |
|
|
| sized |
|
|
|
|
Lmtr (Limiter)
Ratio (Ratio)..................... | 1.0:1...50.0:1, Inf:1 | Sets the signal compression ratio | |
Thrshl (Threshold [dB]) ................... | 0dB | Sets the level above which the compres- | |
|
|
| sor is applied |
Attck (Attack)....................................... | 1... | 100 | Sets the attack time |
Relse (Release) .................................. | 1... | 100 | Sets the release time |
GLevel (Gain Adjust [dB]) ... | Sets the limiter output gain | ||
|
|
|
|
AmpSim (Amp Simulator)
Type (Amplifier Type)............... SS, EL84, 6L6 Selects the type of guitar amplifier
MicSim (Mic Simulator)
Refer to p.137.
Decima (Decimator)
LPF (Pre LPF)..................................... | Off, On | Selects whether the harmonic noise | |
|
|
| caused by a decrease in sampling fre- |
|
|
| quency is generated or not |
Fs (Sampling Frequency [Hz]) ..... | 1.0k... | 44.1k | Sets the sampling frequency |
Bit (Resolution) ..................................... | 4...24 | Sets the data bit length | |
HiDamp (High Damp [%]) ................... | 0... | 100 | Sets the ratio of cut of the high range |
Level (Output Level)............................ | 0... | 100 | Sets the decimator output level |
|
|
|
|
Excit2 (Exciter2)
This adds Pre LEQ and Pre HEQ to Exciter 1.
Blend (Exciter Blend)................... | ... | +100 | Sets the intensity (depth) of the Exciter | |
|
|
|
| effect |
Empha (Emphatic Point)...................... | 0... | 140 | Sets the frequency range to be empha- | |
|
|
|
| sized |
Trim (EQ Trim) ..................................... | 0... | 100 | Sets the EQ input level | |
LEQG (Pre LEQ Gain [dB]) ........ | +15dB | Sets the gain of Low EQ | ||
HEQG (Pre HEQ Gain [dB]) ....... | +15dB | Sets the gain of High EQ | ||
Wah (Wah/Auto Wah)
FcBtm (Frequency Bottom) | .................0... | 100 | Sets the lower limit of the wah center fre- |
|
|
| quency |
FcTop (Frequency Top)........................ | 0... | 100 | Sets the upper limit of the wah center |
|
|
| frequency |
*Mode (Sweep Mode) ........... | Auto, Pedal, LFO | Selects the control from | |
|
|
| ulation source, and LFO |
*Speed (LFO Frequency [Hz]).... 0.02...20.0Hz | Sets the LFO speed | ||
Reso (Resonance) .............................. | 0... | 100 | Sets the resonance amount |
LPF (LPF)........................................... | Off, On | Switches the wah low pass filter on and | |
|
|
| off |
|
|
|
|
:Mode
Select “Pedal” if you wish to use an expression pedal to control the wah.
Comp1 (Compressor1)
Sense (Sensitivity)............................... | 1 | ...100 | Sets the sensitivity |
Attack (Attack) ..................................... | 1 | ...100 | Sets the attack level |
Level (Output Level) ............................ | 0 | ...100 | Sets the output level of the compressor |
Comp2 (Compressor2)
This effect adds Pre LEQ and Pre HEQ to Comp1.
Sense (Sensitivity)............................... | 1... | 100 | Sets the sensitivity |
Attack (Attack) ..................................... | 1... | 100 | Sets the attack level |
Trim (EQ Trim) ..................................... | 0... | 100 | Sets the EQ input level |
|
|
|
|
ODHiG (OverDrive/HighGain)
Mode (Drive Mode) |
|
|
| Switching between overdrive and hyper- |
......................... OD(Overdrive), | gain mode | |||
*Drive (Drive) ........................................ | 1... | 100 | Sets the degree of distortion | |
Level (Output Level).............................. | 0... | 50 | Sets the overdrive output level | |
LoFc (Low Cutoff [Hz]) ............. | 20Hz... | 1.0kHz | Sets the center frequency for Low EQ | |
|
|
|
| (shelving type) |
LoG (Gain [dB])........................... | +18dB | Sets the gain of Low EQ | ||
Md1Fc (Mid1 Cutoff [Hz]) |
|
|
| Sets the center frequency for Mid/High |
............................................. | 300Hz... | 10.0kHz | EQ 1 (peaking type) | |
Md1Q (Q) ........................................ | 0.5... | 10.0 | Sets the band width of Mid/High EQ 1 | |
Md1G (Gain [dB])........................ | +18dB | Sets the gain of Mid/High EQ 1 | ||
Md2Fc (Mid2 Cutoff [Hz]) |
|
|
| Sets the center frequency for Mid/High |
............................................. | 500Hz... | 20.0kHz | EQ 2 (peaking type) | |
Md2Q (Q) ........................................ | 0.5... | 10.0 | Sets the band width of Mid/High EQ 2 | |
Md2G (Gain [dB])........................ | +18dB | Sets the gain of Mid/High EQ 2 | ||
|
|
|
|
|
ChFl1 (Chorus/Flanger1)
DTime (Delay Time [msec]) | ....... 0.0... | 50.0ms | Sets the delay time | |
LFO (LFO Waveform)....................... | TRI, SIN | Selects LFO Waveform | ||
*Speed (Frequency [Hz]) ............ | 0.02... | 20.0Hz | Sets the LFO speed | |
*Depth (Depth)...................................... | 0 | ...100 | Sets the depth of LFO modulation | |
Fdback (Feedback) ..................... | +100 | Sets the feedback amount | ||
Mix (Wet/Dry) ..................... | Sets the effect balance of the chorus/ | |||
| 1:99... | Wet | flanger | |
|
|
|
|
|
ChFl2 (Chorus/Flanger2)
DTime (Delay Time [msec]) | ....... | 0.0... | 50.0ms | Sets the delay time | |
LFO (LFO Waveform)....................... | TRI, SIN | Selects LFO Waveform | |||
*Speed (Frequency [Hz]) ............ | 0.02... | 20.0Hz | Sets the LFO speed | ||
*Depth (Depth)...................................... |
| 0 | ...100 | Sets the depth of LFO modulation | |
Fdback (Feedback) ..................... | +100 | Sets the feedback amount | |||
EQTrim (EQ Trim)................................ |
| 0... | 100 | Sets the EQ input level | |
LEQG (Pre LEQ Gain [dB])......... | +15dB | Sets the gain of Low EQ | |||
HEQG (Pre HEQ Gain [dB]) ....... | +15dB | Sets the gain of High EQ | |||
Mix (Wet/Dry) ..................... | Sets the effect balance of the chorus/ | ||||
|
| 1:99... | Wet | flanger | |
|
|
|
|
|
|
139