The D1200 won’t receive MMC

In the [SYSTEM/USB] “MIDI” tab page, is “RcvMMC” turned “On”?

In the above page, is “MMC DevID” set to match the MMC device ID setting of your MIDI sequencer? (→ p.79, 102)

For some MIDI sequencers, the MMC device ID setting may differ.

Is your MIDI sequencer set to transmit MMC?

Refer to the owner’s manual of your MIDI sequencer.

Can’t use MIDI to control effects or scenes

Are the D1200 and your MIDI sequencer set to the same MIDI channel?

In the [SYSTEM/USB] “MIDI” tab page, check the “Glo- balCh.” (→ p.79, 101)

The D1200 does not synchronize as a slave

If the D1200 is set as an MTC slave, it may take several seconds for synchronization to occur.

Can’t control another device via MMC

In the [SYSTEM/USB] “MMC” tab page, is “Select MMC Mode” set to “Transmit”?

Is the MMC slave device set so that it will receive MMC?

The D1200 does not transmit mixer parameters

In the [SYSTEM/USB] “MIDI” tab page, is “Control- Change” “Trans” turned “On”?

Is the device receiving the control changes set to record each MIDI channel 1–12?

The D1200 does not receive mixer parameters

In the [SYSTEM/USB] “MIDI” tab page, is “Control- Change” “Recv” turned “On”?

CD-R/RW

CD-R/RW drive option is not recognized

Is the CD-R/RW drive option installed correctly?

Turn off the power of the D1200, and check the connec- tions. (→ p.150)

Can’t write

No further data can be written to a CD-R/RW disc that has been finalized. (→ p.65, 76)

No data can be written to a CD-RW disc that contains data written by another device.

Failed while writing to CD

Select a slower writing speed.

Use media that is recommended for your drive.

Some writing speeds cannot be selected when writing a CD.

The speeds that you can select will depend on the type of

media and on the specifications of the CDRW-1. (→ p.93)

Can’t play back on an audio CD player

Did you finalize the disc?

In the [CD] “CD-R/RW” tab page, press the “Final” but- ton to finalize the disc. (→ p.65)

Did you use CD-R media?

Some CD players are unable to play back CD-RW media. We recommend that you use CD-R media.

Have you tried using a different type of media?

Even when the recommended media is used, some CD players are unable to play back certain types of CD-R media. You may be able to play back successfully if you use a different type of CD-R media.

Can’t back up to CD-R/RW

Are you using blank media?

If using CD-R, you must use new (unused) media. If us- ing CD-RW, go to the [CD] “CD-R/RW” tab page and use the “Erase” button to erase the media before you ex- ecute the backup operation.

WAV

Can’t preview

Is the WAV file in a supported format?

Select a WAV file of a format that the D1200 supports, and preview it. (→ p.71, 113)

USB

Computer does not recognize the D1200

Is the USB cable connected correctly? (→ p.15) Is the D1200 set to USB mode? (→ p.77)

Error occurred when you disconnected the D1200 from the computer

Use the correct procedure to disconnect. (→ p.77)

When you connected the D1200, the computer asked you to install software or a device driver

Does the operating system of your computer support the D1200? (→ p.77)

146