In the Sequencer P0: Play/REC, Preference page, the “Multi REC” check box will be checked.

If you are using the arpeggiator, press the ARPEGGIA- TOR [ON/OFF] key to turn it off, and then turn it on again.

3Begin recording.

Press the [LOCATE] key to set the location to 001:01.000.

Press the SEQUENCER [REC/WRITE] key, and then press the SEQUENCER [START/STOP] key.

If you play a B3 note or lower during the pre-count before recording, the arpeggio pattern will start from the beginning at the moment that recording begins. Record your performance.

4When you are finished performing, press the SEQUENCER [START/STOP] key.

If you made a mistake or want to re-record, you can use the Compare function (press the [COMPARE] key) to re-record as many times as you want. (The “Multi- REC” check box will be unchecked when you use Compare, so you will need to check it again.)

If the recorded performance is not reproduced cor- rectly during playback

If you use the page menu command “Copy From Combi” to copy the settings of a combination, and then perform multi-track recording with the arpeggiator turned on, there may be cases in which the performance during recording is not reproduced correctly during playback.

Multiple tracks that are set to the same MIDI channel are combined into a single stream of performance data during recording. If there is a track with the same MIDI channel as the track being played by the arpeggiator, the data played by the arpeggiator will be combined with the per- formance data that was played manually, and all of this data will be sounded by each track of the same channel (if “Status” is INT).

In such cases, you can solve the problem by changing the MIDI channel of the track that is played by the arpeggiator, and then creating a track that will drive the arpeggiator.

If the recorded performance is not reproduced by the playback, check the following conditions.

These settings can be executed automatically if you check “Auto adjust Arp setting for Multi REC” in the page menu command “Copy From Combi.” Nor- mally, you will check this to execute the settings. In this case, these adjustments will not be necessary, but you can verify here that the automatic adjustments have been made.

Sequencer P7: Arpeggiator, Setup T01–08 page “Arpeggiator Run” A, B, and “Arpeggiator Assign” settings

Sequencer P2: Trk Param, MIDI Ch T01–08 page “MIDI Channel” settings

If “Arpeggiator Run” A and B are checked, and the arpeggiator is assigned to a track, make sure that “MIDI Channel” is set to other than 01.

Make sure that the global MIDI channel (Global P1: MIDI, “MIDI Channel”) is set to 01.

Arpeggiator Run

MIDI Channel*1

Correction

If either “A” or “B”

01 only

Correction required

are checked

 

 

 

01

02, 01 03, etc.

No correction required

 

 

 

 

If both “A” and “B”

01 only

Correction required

are checked

 

 

 

01

02, 01 03, etc.

Correction required for

 

 

 

 

only one

 

 

 

 

 

01

02 03, etc.

No correction required/

 

 

 

Correction required*2

96

Page 104
Image 104
Korg music workstation, sampler manual Correction required*2