3.Specify the recording method (Recording Setup)

1Set “Source BUS” to L/R.

Now you can sample the sound of the L/R channels, which is output from the headphones and from AUDIO OUTPUT (MAIN) L/MONO and R.

2Set “Trigger” to Threshold, and set “Level” to –30.

With this setting, recording will begin automatically when the audio input reaches –30 dB or higher in record-ready mode.

3Set “Pre Trigger” to 005 ms.

With this setting, sample recording will begin 5 ms ear- lier than (i.e., immediately before) sampling is actually triggered, so that the very beginning of the sound is not lost.

In Sampling mode, the “Trigger” parameter which specifies how recording will begin can be set to vari- ous settings other than the Threshold setting used above. You can choose Sampling START SW so that recording will begin when you press the SAMPLING [START] key, or Note On so that recording will begin when you play the keyboard. (p.43, 45)

4.Settings for the sample that will be recorded (REC Sample Setup)

1Press the Recording tab to access the P0: Recording, Recording page.

2Set “Save to” to RAM.

The sample you record will be written into sample memory (RAM). (For details on the DISK setting, refer to p.105)

3Set “Sampling Mode” to L-Mono.

With this setting, the internal L channel will be sam- pled in mono.

5. Create a multisample and indexes

1In the upper left of the P0: Recording, Recording page, make sure that 000 is selected for “MS” (multi- sample).

When you want to create a new multisample, press the “MS (Multisample Select)” popup button, press a Multisample No. (or use the numeric keys to input a number) for which there is no name in the list, and then press the [ENTER] key. (p.106)

2Set “OrigKey (Original Key)” and “TopKey” to C2.

When you play the key designated by “OrigKey,” the sample will sound at the same pitch at which it was sampled.

You can make this setting easily by holding down the [ENTER] key and pressing the C2 key. If you want to use the numeric keys to input this setting, press [3], [6], and [ENTER].

3Press the Preference tab to access the P0: Recording, Preference page.

4Set “Zone Range” to 1 Key.

When you create a new index, the width of the zone will be set to one key.

5Press the “Auto Loop On” check box to uncheck it.

Looping will automatically be turned off for the sam- ple that is recorded.

38

Page 46
Image 46
Korg music workstation, sampler manual Specify the recording method Recording Setup, Create a multisample and indexes