Korg music workstation, sampler manual Rear panel

17 18 19

17. Headphone jack

A set of headphones can be connected here (stereo 1/4" jack).

This allows stereo monitoring of the same signal as the OUTPUT L/MONO and R jacks.

18. Floppy disk drive

3.5inch 2DD (double-side double-density) or 2HD (dou- ble-side high-density) floppy disks can be inserted here, allowing you to save your edited data, or to load factory- set data, SMF data, or multisample/sample data, etc...

For details on handling floppy disks, refer to “Cautions when handling floppy disks” (☞p.62).

Eject button

To remove a floppy disk, make sure that the disk access indicator is dark, and then press this button. If the disk is not ejected when you press this button, do not attempt to forcibly remove the disk, but contact your Korg distribu- tor.

Eject button

Disk access indicator

19. CDRW-1 drive bay

The CDRW-1 (CD-R/RW drive) option can be installed in this bay. (☞PG p.286)

Rear panel

2 7 8 9 10 12

1 11 5 6 4 3

1. AC power supply connector

Connect the included power supply cable here.

After connecting the power supply cable to the TRITON STUDIO, connect the other end to an AC outlet (☞p.11).

tor, an insert effect, an individual drum part, or the metro- nome etc. can be assigned to be output from the (INDIVIDUAL) 1, 2, 3, 4, jacks.

The output from the 1, 2, 3, 4 jacks is not affected by the [VOLUME] slider.

2. [POWER] switch

This switch turns the power on/off (☞p.19).

3. AUDIO OUTPUT

Connect these outputs to the input jacks of your amp or mixer. In addition to the L/MONO and R main stereo audio outputs, the TRITON STUDIO provides four indi- vidual audio outputs. The sound from each oscillator, drum, timbre/track, or insert effect can be freely routed to any output (☞p.139–).

4. AUDIO INPUT

These two audio inputs are used when recording a mono/ stereo sample from a mic or external audio source (☞p.37), or when applying the TRITON STUDIO’s inter- nal effects to an external audio source (☞p.143).

The MIC/LINE level select switch ([MIC/LINE] switch) and the level adjustment knob ([LEVEL] knob) allow you to use a wide range of external audio sources, ranging from mic level to line level.

(MAIN) L/MONO, R

These are unbalanced phone jacks.

These are the main audio output jacks. By setting “Bus Select” to L/R, the output from an oscillator, an insert effect, an individual drum part, or the metronome can be output to the (MAIN) L/MONO and R jacks.

When making connections in stereo, use L/MONO and R. When making connections in mono, use the L/MONO jack.

(INDIVIDUAL) 1, 2, 3, 4

These are unbalanced phone jacks.

These are individual (independent) audio output jacks. By setting the “Bus Select” to 1, 2, 3, 4, 1/2, or 3/4, an oscilla-

AUDIO INPUT 1/2 jacks

These are unbalanced phone jacks.

[LEVEL] knob

This adjusts the input level of the AUDIO INPUT 1/2 jacks.

[MIC/LINE] switch

This switches the input level of the AUDIO INPUT 1/2 jacks.

6