Troubleshooting, Power supply, LCD screen, 147

Appendices

Troubleshooting

If you experience problems, refer to the relevant item and take the appropriate measures.

Power supply

Power does not turn on

Is the power cable connected to an outlet? ☞p.11

Is the [POWER] switch turned on?

→Turn on the rear panel [POWER] switch. ☞p.19

LCD screen

The power is turned on, but nothing is shown in the LCD screen.

The TRITON STUDIO functions normally when you play the keyboard or perform other operations.

Use the rear panel [Contrast adjustment] knob to adjust the contrast of the LCD screen. ☞p.7

The power is turned on, but the LCD screen does not display normally, or an error message is dis- played. There is no sound when you play the key- board, and the TRITON STUDIO does not function normally.

This type of problem may occur if a data writing operation to internal memory was not completed correctly, for example if the power of the TRITON STUDIO was turned off while a program or other data was being written. If this occurs, use the following procedure to initialize the TRITON STUDIO’s internal memory.

1Turn off the power.

2Hold down the [MENU] key and the [9] key, and turn on the power.

The TRITON STUDIO will be initialized, and data will be written into internal memory. While the data is being written, the LCD screen will indicate “Now writing into internal memory.”

After initialization, you will need to load the pre- loaded data. Load the data from the included ﬂoppy disk or the internal hard drive. ☞p.20, 63

Can’t operate the LCD screen correctly

In Global P0: Basic Setup, execute the “Touch Panel Calibration” page menu command to adjust the sensitivity of the touch panel. ☞PG p.137

If it is not possible to select this command from the page menu, enter Global mode P0 (press the [MENU] key, and then press the [0] or [EXIT] key

to access this), and then hold down the [ENTER] key and press numeric key [2] to display the dialog box.

Can’t switch modes or pages

Are you recording or playing a song?

Are you sampling?

Are you playing a CD?

Are you playing a WAVE file?

In Combination, Sequencer, or Song Play modes, can’t edit the value of Timbre/Track parameters such as “MIDI Channel” or “Status”

Some parameters cannot be edited during a “note- on” condition; i.e., while a note is held down on the keyboard, or while the damper pedal is held down.

→Are you using a damper pedal with a polarity that does not match the “Damper Polarity” setting (Glo- bal P2: Controller)?

→In some cases, this problem can be solved be execut- ing the page menu command “Half Damper Cali- bration” (Global P0: Basic Setup).

No beep is sounded when you touch the LCD screen

Check the “Beep Enable” check box (Global P0: Basic Setup, System Preference). ☞p.146

Audio input and output

No sound

Are connections made correctly to your amp, mixer, or headphones? ☞p.11

Is the connected amp or mixer powered-on, and is its volume raised?

Is Local Control turned on?

→In Global P1: MIDI, check the “Local Control On” check box. ☞PG p.142

Is the [VOLUME] slider raised? ☞p.3

If there is no sound from the OUTPUT (INDIVIDUAL) 1–4 jacks, make sure that “BUS Select” or “Bus Select” following the insert effect is set to 1, 2, 3, 4, 1/2, or 3/4. ☞p.140

If specific tracks in Sequencer mode or Song Play mode do not sound, Make sure that the PLAY/ MUTE/REC button or PLAY/MUTE button is set to PLAY. ☞p.83, 123