Korg music workstation Adjusting the stereo position, Adjusting the volume, Writing a Combination

If you wish to select a different program from the same category, press the desired program. That pro- gram will be highlighted. Press the scroll bar to see other programs in the same category.

If you wish to select a program from a different cate- gory, press one of the tabs located to the left and right to select the desired category. The full name of the selected category will appear in the upper right.

Let’s select the 04: Vocal/Airy category.

Press the 04 Vocal/Airy electric tab, and then press the desired program to select it. The program you pressed will be highlighted. Press the scroll bar to see other programs in the same category.

For this example, select INT-C027: Dream Voices. This will produce a layered combination consisting of a piano and voice.

6If you are satisfied with the selected program, press the OK button to close the popup menu.

If you press the Cancel button, your selection will be discarded, and you will return to the program that had been selected before the popup menu was opened. For this example, press the OK button.

Adjusting the stereo position

7Press the Mixer tab.

8Press “Pan” for timbre 2 (it will be highlighted), and use the VALUE controllers to edit the setting.

With a setting of C064 the sound will be located in the center. A setting of L001 places the sound at the far left, and R127 at the far right. With a setting of RND, the sound will move randomly between left and right each time a note is played.

Adjusting the volume

9Press “Volume” for timbre 2 (it will be highlighted), and use the VALUE controllers to edit the setting.

If you check “Hold Balance” and adjust the “Vol- ume” value, the volume balance between the timbres at the time that “Hold Balance” was checked will be maintained while the volume of all timbres is adjusted.

Writing a Combination

The edited content will be lost if you select another Combination or turn off the power before saving.

If you want to save the modified sound, select the page menu command “Write Combination,” and write the program. (☞p.56)

It is best to write your own edited Combinations into an initial (initialized) combination of bank INT-E or EXB-A–EXB-G. You should also give a new name to the combination you are writing.

If you want to overwrite the combination using the same combination number, press the SEQUENCER [REC/WRITE] key and then press the OK button.

36