Korg sampler, music workstation manual Recalling the last-selected mode and page at power-on, 125

Recalling the last-selected mode and page at power-on

The state of TRITON STUDIO when the power is turned on will depend on the setting of “Power On Mode” (Glo- bal P0: System Preference page).

If “Power On Mode” is Reset (factory setting), TRITON STUDIO will automatically selects the Combination mode P0: Play.

If “Power On Mode” is Memorize, TRITON STUDIO will be in the mode and page that were last selected when the power was turned off.

The Memorize setting will remember the mode and page that were last selected, the combination number that was last selected in Combination mode, and the program number that was last selected in Program mode. If another mode is selected when the power is turned on, you can press the [COMBI] key or [PROG] key to select the P0: Play page with the last-selected combination num- ber or program number.

Specifying the function of the ASSIGNABLE Switch and ASSIGNABLE Pedal

Sets the function of an assignable switch such as the optional Korg PS-1 connected to the ASSIGNABLE SWITCH jack.

This switch can act as a source for alternate modulation or effect dynamic modulation, or switch portamento on/off, control the sostenuto effect, turn the soft pedal effect on/ off, turn the arpeggiator on/off, select programs or combi- nations (up/down), start/stop the sequencer, punch-in/ out on the sequencer, or be a trigger to advance the cue list step (☞PG p.251).

•This setting is made in Global P2: Controller “Foot Switch Assign.”

You can specify the function that will be performed by an assignable pedal (the optional XVP-10 or EXP-2) con- nected to the ASSIGNABLE PEDAL jack.

This pedal can be used to control master volume, alternate modulation or effect dynamic modulation, portamento pitch change speed, volume, the pan following an insert effect, pan, volume, or send levels to the master effects (☞PG p.252).

•This setting is made in Global P2: Controller “Foot Pedal Assign.”

You can use this as a source for alternate modulation or effect dynamic modulation, and use it to control program parameters or effect parameters. In this case, set “Foot Switch Assign” to Foot SW (CC#82), and “Foot Pedal Assign” to Foot Pedal (CC#04).

Here we will show how to make settings that allow an assignable switch to change programs or combinations.

1Connect an optional Korg PS-1 to the ASSIGNABLE SWITCH jack.

2Press the [GLOBAL] key to enter Global mode.

3After pressing the [MENU] key, and press the P2: Controller.

4Press the “Foot Switch Assign” popup button, and press either Program Up or Program Down.

Program Up will cause the next higher program num- ber to be selected each time you press the foot switch. Program Down will cause the next lower program number to be selected each time you press the foot switch.

5Set the “Foot Switch Polarity” to the polarity of the foot switch you have connected.

If you have connected a Korg PS-1 pedal switch, set this to (–) KORG Standard. If the polarity is not set correctly, the pedal will not function appropriately.

6Either press the [PROG] key to enter Program P0: Play, or press the [COMBI] key to enter Combination P0: Play. When you press the foot switch, the pro- gram/combination will change.

Basic functions
Saving data
Loading data
Program	settings
Combination	settings
Producing	songs
Sampling	settings
Creating a	CD
SMF	playback
System	settings
Drum kit	settings
Arpeggiator	settings
Effects	settings
Other	functions

125