Kyocera FS-C5100DN, FS-C5300DN manual Password Change ID, 002, Change ID Administrator ID change

Password _

>Change ID 00000001

>Change ID 001

>Change ID _

OK?

002

Password (Administrator Password input)

You can use this to set the administrator password. The default setting is the numeric part of your printer's model name. If you use FS-C5300DN, enter "5300".

1Once you have entered the correct ID in the previous step (ID (Administrator ID input)), the message display shows Password (Administrator password input) and a blinking cursor (_).

2Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the specified password. Use Y and Z to move the cursor right and left. Enter a password consisting of between 0 and 16 numbers.

Note If you enter the incorrect administrator ID or password, the Wrong ID or Wrong Password message appears and the input screen then reappears. Re-enter the ID or password correctly.

3Once you enter the correct ID and password, the Admin (change) screen appears. (E.g.: Where the administrator ID is 00000001)

Each time you press U or V, the following settings to be changed appear in succession.

•Change ID

•Change Password

Note If a change is required, refer to the procedures in Change ID (Administrator ID change) and Change Password (Administrator Password change) below.

4Press [OK] again. The administrator ID and password are confirmed.

5Press [MENU]. The display returns to Ready.

Change ID (Administrator ID change)

You can use this to change the administrator ID.

1In step 3 in Password (Administrator Password input) above, press U or V while the Admin (Change) screen is displayed until >Change ID appears. (E.g.: Where the administrator ID is 001)

2When you press [OK], a blinking cursor (_) appears.

3Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the ID to be changed. Use Y and Z to move the cursor right and left. Enter an ID consisting of between 1 and 16 numbers.

4Press [OK]. A confirmation screen appears. (E.g.: Where the administrator ID is changed to 002)

5Press [OK]. The new administrator ID is confirmed.

6Press [MENU]. The display returns to Ready.

6-76 Using the Operation Panel