Kyocera FS-C5100DN manual Password Block USB Host ? Unblock, Password Administrator Password input

Password

_

>I/F Block >

>>USB Host ?Unblock

Password (Administrator Password input)

To set up the Security functions, you must enter an administrator ID and administrator password. For information on how to set the administrator password, refer to Admin (Administrator settings) on page 6-75.

1Once you have entered the correct ID in the previous step (ID (Administrator ID input)), the message display shows Password (Administrator password input) and a blinking cursor (_).

2Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the specified password. Use Y and Z to move the cursor right and left. Enter a password consisting of between 0 (no settings) and 16 numbers.

Note If you enter the incorrect administrator ID or password, the message ID error or Wrong Password appears and the input screen then reappears. Re-enter the ID or password correctly.

3Press [OK]. The Security screen appears.

I/F Block (Interface (external device) block setting)

You can use this to lock and thereby protect the interface. The options available in Interface Block are as follows:

•USB Host (USB memory slot setting)

•USB Device (USB interface setting)

•Optional interface (Network interface card setting)

1After entering the administrator ID and password, press U or V

repeatedly until >I/F Block > appears.

USB Host (USB memory slot setting)

This locks and protects the USB memory slot (USB host). The default setting is Unblock.

1 Press Z while >I/F Block	> is displayed. >>USB Host
appears.

2Press [OK]. A blinking question mark (?) appears.

3Select Block or Unblock using U or V.

4Press [OK].

5Press [MENU]. The display returns to Ready.

Using the Operation Panel 6-61