Kyocera FS-C5200DN manual Being used, Previous screen is displayed again 1 or 2 seconds, Format

Message		Corrective Action
		The top cover of the printer is open. Close the printer top cover.
	Close
	top cover
		This message is displayed when Remove Device was selected while a USB memory was
	Device busy	being used.
		The previous screen is displayed again 1 or 2 seconds.
		You attempted to print with a paper size and paper type that cannot be used for duplex
	Duplex disabled
	Press GO	printing. Press [GO] to print onto one-side of the paper only.
		An account code must be entered. This message is displayed if you try to print from the
	Enter Account
		operation panel (e.g. printing a status page or using the Job Retention function) when the Job
		Accounting function is enabled. For more information, refer to Job Accounting (Job
		Accounting selection/setting) section of the Advanced Operation Guide.
		Displayed when the envelope switch is set to envelope mode.
	Envelope mode
		If the Attention indicator is flashing, check the installed optional hard disk or the memory card
		format.
		Turn the power switch off and then back on again. If this message still remains, turn the
	Error.Power off.
	F###	power switch off, and contact your service representative or authorized service center.
		The printer controller and operation panel cannot exchange data. Turn the printer off and
	Error.Power off.
	F000	unplug it from the mains power supply. Then contact your service representative or
		authorized service center. See the back page of this manual for the relevant phone numbers.
		This message is displayed when the Job Accounting function is enabled and an attempt has
	Exceeded Max.out
	Press GO	been made to exceed the print limit set for each account. To return the printer to the print-
		ready status, press [GO].
		For more information, refer to Job Accounting (Job Accounting selection/setting) section of
		the Advanced Operation Guide.
		The specified file was not found on the hard disk, RAM disk or memory card. For more
	File not found
	Press GO	information on the hard disk, RAM disk and memory cards, refer to Device Common
		(Selecting/Setting the common device) section of the Advanced Operation Guide.
		The hard disk installed in the printer is not formatted, and therefore cannot be read or written.
	Format error
	Hard disk
		The memory card inserted in the printer is not formatted, and therefore cannot be read or
	Format error
	Memory card	written. To format a memory card, follow the procedure in Memory Card (Using the memory
		card) section of the Advanced Operation Guide.
		A hard disk error has occurred. Look at the error code given in place of ## and refer to
	Hard disk err ##
	Press GO	Storage Error Codes on page 5-10. To ignore the hard disk error, press [GO].
		The user ID entered for a private job is not correct. Check the user ID that you specified on
	ID error	the printer driver. For more information, refer to Job Box section of the Advanced Operation
		Guide.
		This message is displayed when the Job Accounting function is enabled and no account is
	Illegal Account
	Press GO	set for a transmitted print job or the specified account is not registered (the incorrect account
		is set). To return the printer to the print-ready status, press [GO].
		For more information, refer to Job Accounting (Job Accounting selection/setting) section of
		the Advanced Operation Guide.
		Replace Maintenance Kit which is displayed on the message display. Replacement of the
	Install MK
		maintenance kit is necessary at every 200,000 images of printing and requires professional
		servicing. Contact your service technician.

Troubleshooting 5-7