Kyocera FS-C5200DN manual Password Job Accounting ? Off Enter Account, Job Accounting Enabled

Password

_

>Job Accounting ?Off

Enter Account _

Password (Administrator Password input)

To set up Job Accounting, you must enter an administrator ID and administrator password. For information on how to set the administrator password, refer to Admin (Administrator settings) on page 6-75.

1Once you have entered the correct ID in the previous step (ID (Administrator ID input)), the message display shows Password (Administrator password input) and a blinking cursor (_).

2Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the specified password. Use Y and Z to move the cursor right and left. Enter a password consisting of between 0 and 16 numbers.

Note If you enter the incorrect administrator ID or password, the message ID error or Wrong Password appears and the input screen then reappears. Re-enter the ID or password correctly.

3Press [OK]. The Job Accounting selection/setting screen reappears.

Job Accounting (Job Accounting selection/setting)

This allows you to turn the Job Accounting function On and Off. The default setting is Off.

1After entering the administrator ID and password, press U or V repeatedly until >Job Accounting appears.

2Press [OK]. A blinking question mark (?) appears.

3Select On or Off using U or V.

4Press [OK].

5Press [MENU]. The display returns to Ready.

Job Accounting Enabled

If department administration is enabled, an account ID entry screen appears each time you retrieve a status page or list.

1A blinking cursor (_) appears in the account ID entry screen.

2Press U or V to increase or decrease, respectively, the value at the blinking cursor. Enter the specified account ID. Use Y and Z to move the cursor right and left. Enter an account ID consisting of between 1 and 8 numbers.

Note If you enter an incorrect account ID, the input screen reappears. Re-enter the account ID correctly.

3Press [OK]. The account is confirmed and printing begins.

Using the Operation Panel 6-69