6 Line, Tunnel, Terminal, and Host Settings
Tunnel - | Description |
Accept Mode |
|
Page Settings |
|
|
|
| Modem Control Asserted = start waiting for an incoming |
| connection as long as the Modem Control pin (DSR) is |
| asserted on the serial line until a connection is made. |
| Modem Emulation = start waiting for an incoming connection |
| when triggered by modem emulation AT commands. Connect |
| mode must also be set to Modem Emulation. |
|
|
Local Port | Enter the port number for use as the local port. The defaults |
| are port 10001 for Tunnel 1 and port 10002 for Tunnel 2. |
|
|
Protocol | Select the protocol type for use with Accept Mode. The default |
| protocol is TCP. If you select TCP AES you will need to |
| configure the AES keys. |
|
|
TCP Keep | Enter the time, in seconds, the XPort Pro waits during a silent |
Alive | connection before checking if the currently connected network |
| device is still on the network. If the unit then gets no response |
| after 8 attempts, it drops that connection. |
|
|
Flush Serial | Select Enabled to flush the serial data buffer on a new |
Data | connection. |
|
|
Block Serial | Select On to block, or not tunnel, serial data transmitted to the |
Data | XPort Pro. |
|
|
Block Network | Select On to block, or not tunnel, network data transmitted to |
Data | the XPort Pro. |
|
|
Password | Enter a password that clients must send to the XPort Pro |
| within 30 seconds from opening a network connection to |
| enable data transmission. |
| The password can have up to 31 characters and must contain |
| only alphanumeric characters and punctuation. When set, the |
| password sent to the XPort Pro must be terminated with one of |
| the following: (a) 0x0A (LF), (b) 0x00, (c) 0x0D 0x0A (CR LF), |
| or (d) 0x0D 0x00. |
|
|
Email on | Select whether the XPort Pro sends an email when a |
Connect | connection is made. Select None if you do not want to send an |
| email. Otherwise, select the Email profile to use for sending. |
|
|
Email on | Select whether the XPort Pro sends an email when a |
Disconnect | connection is closed. Select None if you do not want to send |
| an email. Otherwise, select the Email profile to use for |
| sending. |
|
|
CP Output | Identifies a CP or CP Group whose value should change when |
| a connection is established and dropped. |
|
|
3.Click Submit.
XPort Pro™ User Guide | 43 |
