
6 Line, Tunnel, Terminal, and Host Settings
Line – | Description |
Command Mode |
|
Page Settings |
|
|
|
| the value of the CP group must be matched to enable |
| Command Mode. |
| Disabled = turns off Command Mode. |
|
|
Wait Time | Enter the wait time for the serial string during |
| milliseconds. |
|
|
Serial String | Enter the serial string characters. Select a string type. |
| Text = string of bytes that must be read on the Serial Line |
| during boot time to enable Command Mode. It may contain a |
| time element in x milliseconds, in the format {x}, to specify a |
| required delay. |
| Binary = string of characters representing byte values where |
| each hexadecimal byte value starts with \0x and each |
| decimal byte value starts with \. |
|
|
Echo Serial | Select Yes to enable echoing of the serial string at |
String |
|
|
|
CP Group | Enter the name and decimal value of the CP group. |
|
|
Signon | Enter the |
Message |
|
| Text = string of bytes sent on the serial line during boot time. |
| Binary = one or more byte values separated by commas. |
| Each byte value may be decimal or hexadecimal. Start |
| hexadecimal values with 0x. |
| Note: This string will be output on the serial port at boot, |
| regardless of whether command mode is enabled or not. |
|
|
3.In the Current Configuration table, clear currently stored settings as necessary.
4.Click Submit.
Tunnel Settings
The Tunnel pages allow you to view current statistics and configure serial settings, Connect Mode, Accept Mode, Disconnect Mode, Packing Mode, start and stop characters, modem emulation, and AES keys.
Note: The following section describes the steps to view and configure Tunnel 1 settings; these steps also apply to Tunnel 2 menu options.
XPort Pro™ User Guide | 37 |