Lantronix 900-560 manual Line 1 Command Mode, Description, Configuration, Page Settings

	6 Line, Tunnel, Terminal, and Host Settings
Line -	Description
Configuration
Page Settings
Protocol	Select the protocol from the drop-down menu. The default is
	Tunnel.
Baud Rate	Select the baud rate from the drop-down menu. The default
	is 9600.
Parity	Select the parity from the drop-down menu. The default is
	None.
Data Bits	Select the number of data bits from the drop-down menu.
	The default is 8.
Stop Bits	Select the number of stop bits from the drop-down menu.
	The default is 1.
Flow Control	Select the flow control from the drop-down menu. The
	default is None.
Xon Char	Specify the character to use to start the flow of data when
	Flow Control is set to Software. Prefix a decimal character
	with \ or a hexadecimal character with 0x, or provide a single
	printable character. The default Xon char is 0x11.
Xoff Char	Specify the character to use to stop the flow of data when
	Flow Control is set to Software. Prefix a decimal character
	with \ or a hexadecimal character with 0x, or provide a single
	printable character. The default Xoff char is 0x13.
Gap Timer	The driver forwards received serial bytes after the Gap
	Timer delay from the last character received. By default, the
	delay is four character periods at the current baud rate
	(minimum 1 ms).
Threshold	The driver will also forward received characters after
	Threshold bytes have been received.

3.Click Submit.

Line 1 Command Mode

Setting Command Mode enables the CLI on the serial line.

To configure Line 1 Command Mode:

1.Click Line 1 and Command Mode at the top of the page. The Line 1 Command Mode page appears.

XPort Pro™ User Guide 35