Lexmark 037 Verifying printer setup, Printing a menu settings page, Printing a network setup page

Additional printer setup 64

In Windows 7 or earlier

1Click or click Start, and then click Run.

2In the Start Search or Run dialog, type devmgmt.msc.

3Press Enter or click OK.

bDouble‑click Ports (COM & LPT) to expand the list of available ports.

cDo either of the following:

•Press and hold the COM port where you attached the serial cable to your computer (example: COM1).

•Right‑click the COM port where you attached the serial cable to your computer (example: COM1).

dFrom the menu that appears, select Properties.

eOn the Port Settings tab, set the serial parameters to the same serial parameters set in the printer. Check the serial heading of the menu settings page for the printer settings.

fClick OK, and then close all the dialogs.

gPrint a test page to verify printer installation.

Verifying printer setup

When all hardware and software options are installed and the printer is turned on, verify that the printer is set up correctly by printing the following:

•Menu settings page—Use this page to verify that all printer options are installed correctly. A list of installed options appears toward the bottom of the page. If an option you installed is not listed, then it is not installed correctly. Remove the option, and then install it again.

•Network setup page—If your printer has Ethernet or wireless capability and is attached to a network, then print a network setup page to verify the network connection. This page also provides important information that aids network printing configuration.

Printing a menu settings page

From the home screen, navigate to:

> Reports > Menu Settings Page

Printing a network setup page

If the printer is attached to a network, then print a network setup page to verify the network connection. This page also provides important information that aids network printing configuration.

1From the home screen, navigate to: > Reports > Network Setup Page

2Check the first section of the network setup page, and confirm that the status is Connected.

If the status is Not Connected, then the LAN drop may not be active, or the network cable may be malfunctioning. Consult a system support person for a solution, and then print another network setup page.