Lexmark MX710DHE, 24T7310 Networking, Preparing to set up the printer on an Ethernet network

Additional printer setup 56

5Do either of the following:

•Click Update Now ‑ Ask Printer.

•Under Configuration Options, manually add any installed hardware options.

6Click Apply.

For Macintosh users

1From the Apple menu, navigate to either of the following:

•System Preferences > Print & Scan > select your printer > Options & Supplies > Driver

•System Preferences > Print & Fax > select your printer > Options & Supplies > Driver

2Add any installed hardware options, and then click OK.

Networking

Notes:

•Purchase a MarkNet N8350 wireless network adapter first before setting up the printer on a wireless network. For information on installing the wireless network adapter, see the setup sheet that came with the adapter.

•A Service Set Identifier (SSID) is a name assigned to a wireless network. Wired Equivalent Privacy (WEP), Wi-Fi Protected Access (WPA), and WPA2 are types of security used on a network.

Preparing to set up the printer on an Ethernet network

To configure your printer to connect to an Ethernet network, organize the following information before you begin:

Note: If your network automatically assigns IP addresses to computers and printers, continue on to installing the printer.

•A valid, unique IP address for the printer to use on the network

•The network gateway

•The network mask

•A nickname for the printer (optional)

Note: A printer nickname can make it easier for you to identify your printer on the network. You can choose to use the default printer nickname, or assign a name that is easier for you to remember.

You will need an Ethernet cable to connect the printer to the network and an available port where the printer can physically connect to the network. Use a new network cable when possible to avoid potential problems caused by a damaged cable.