Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
OUTPUT RECTIFIER REMOVAL AND REPLACEMENT (continued)
FIGURE F.39 – CHOKE LEAD/HEAT SINK CONNECTION
HEAT SINK TAB
CHOKE LEAD
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
PROCEDURE
1.Turn off Invertec STT and disconnect main AC input power to the machine.
2.Using the 5/16" nut driver, remove the case wraparound cover.
3.Perform the Input Filter Capacitor Discharge Procedure. See the Maintenance section.
WARNING
ELECTRIC SHOCK can kill.
•Before continuing with the test procedure, per- form the capacitor dis- charge procedure to avoid electric shock.
4.Using the slot head screw driver, loosen the input cable strain relief.
5.Using the 5/16" nut driver, remove the four screws securing the case back to the inter- nal horizontal baffles.
6.Carefully pull the case back away from the output rectifier assembly.
NOTE: The case back will NOT detach from the case bottom.
7.Using the 7/16" wrench, remove the four bolts and washers mounting the fan motor bracket to the top horizontal baffle. Carefully set the fan and motor assembly aside. Note insulation placement for reassembly.
NOTE: The fan motor leads do NOT have to be cut.
8.Using the 7/16" wrench, remove the choke lead from the heat sink tab. See Figure F.39.