OPERATION
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
6.WIRE SIZE SELECT SWITCH: This toggle switch selects between electrode diameters of .035” (1 mm) and smaller or .045” (1.2 mm) and larger. The .035” (1 mm) position provides improved performance of smaller diameter wires at higher wire feed speeds.
7.WIRE TYPE SELECT SWITCH: This toggle switch selects between mild or stainless steel. In the stain- less position, the pulse width of the Peak Current is changed from 1 to 2 ms for better performance for stainless steel welding.
8.THERMAL
the internal components have returned to normal operating temperature (if the thermostat(s) “opened”) or after about
9.REMOTE RECEPTACLE: This is a 10 pin
10.WIRE FEEDER RECEPTACLE: This is 14 pin
connection. 115 and 42 VAC along with the trigger switch connections are provid-
ed. (Only 42 VAC is available on European mod- els). There are no provisions for voltage control of the power source by the wire feeder. Refer to the Accessories section of this manual for wire feeder connection instructions.
11.ARC SENSE RECEPTACLE: This is a four pin MS- type connector for WORK and ELECTRODE sense leads. The STT requires a WORK sense and ELEC- TRODE sense lead for proper operation. The ELECTRODE sense lead is bolted together with power source electrode lead at the wire feeder gun block. The WORK sense lead is furnished with an “alligator” type clip for connection to the work piece. Refer to the LN 742 or
12.42V AUXILIARY POWER CIRCUIT BREAKER: The 42 VAC supply is protected from excessive current
draws with a 6 amp circuit breaker. When the
breaker “trips” its button will extend. Depressing this button will reset the breaker.
13.115V AUXILIARY POWER CIRCUIT BREAKER
(Not on European Models): The 115 VAC supply is protected from excessive current draws with a 6 amp circuit breaker. When
the breaker “trips” its button will extend. Depressing this button will reset the breaker.
14.WORK TERMINAL: This
15.ELECTRODE TERMINAL: This
WELDING OPERATION
Familiarize yourself with the controls on the Invertec STT II before beginning to weld.
Familiarize yourself with the operating manual for the wire feeder and the wire feeder controls before begin- ning to weld.
Set the Wire Size and Wire Type selection switches per the appropriate wire. Refer to “Operational Features and Controls” in this section for the function of these switches.
INVERTEC STT