
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
| ||
TROUBLESHOOTING & REPAIR | ||
Observe Safety Guidelines |
| TROUBLESHOOTING GUIDE |
detailed in the beginning of this manual. |
| |
|
|
|
PROBLEMS | POSSIBLE AREAS OF | RECOMMENDED |
(SYMPTOMS) | MISADJUSTMENT(S) | COURSE OF ACTION |
|
|
|
| WELDING PROBLEMS |
|
Molten weld puddle appears exces- | 1. The Wire Type switch may be in | 1. The IGBT module may be faulty. |
sively "violent." | the wrong position for the elec- | Check or replace. |
| trode wire being used. | 2. The IGBT driver PC board may |
|
| |
| 2. The Peak Current or Back- | be faulty. |
| ground Setting may be too high. | 3. The control PC board may be |
| Adjust for optimum welding per- | |
| faulty. | |
| formance. | |
|
| |
| 3. The Tailout may not be set cor- |
|
| rectly for the process. (STT II |
|
| Only) |
|
|
|
|
CAUTION
If for any reason you do not understand the test procedures or are unable to perform the test/repairs safely, con- tact the Lincoln Electric Service Department for electrical troubleshooting assistance before you proceed.
Call