Minolta Di3510, DI2510, DI2010, DI3010 user manual When Incorrect Copies Are Printed

Troubleshooting Chapter 9

9		9.2 When Incorrect Copies Are Printed
	Symptom	Possible Cause	Remedy
	There are dark specks or spots	The original glass is dirty.	Wipe the glass with a dry soft
	throughout the printed output.		cloth.
		Either the document pad is	Clean the document pad with a
		dirty.	soft cloth dampened with a mild
			detergent.
		The original document is	Place a blank sheet of paper on
		printed on highly translucent	top of the document.
		material, such as diazo
		photosensitive paper or
		overhead projector
		transparencies.
	There are streaks in the printed
		A double-sided document is	If a thin double-sided document
	output.
		being copied.	is being copied, the information
			on the back side may be
			reproduced in the copy. Touch
			[Density], and then select a
			lighter density for the
			background.
	The image is not aligned properly on	The document is not positioned	Correctly position the
	the paper.	correctly.	document against the
			document scales.
			If the duplexing document
			feeder is installed, correctly
			adjust the document guides for
			the size of the document.
		The document is not positioned	Lift open the duplexing
		correctly in the duplexing	document feeder, and correctly
		document feeder.	position the document against
			the document scales.
		The original glass is dirty (while	Wipe the glass with a dry soft
		using the duplexing document	cloth.
		feeder).
		The document guides are not	Slide the document guides
		slid up against the edges of the	against the edges of the
		document.	document.
		Curled paper was loaded into	Flatten the paper before
		the paper drawer.	loading it.
	The printed page is curled.	The paper that was used (as	Remove the paper from the
		with recycled paper) curls	paper drawer, turn it over, and
		easily.	then load it again.
			Replace the paper with paper
			that is not damp.

9-4 Di2010/Di2510/Di3010/Di3510