Reference
67
Program Station Passcode 392 The station passcode is used for the Remote Programming
feature. The passcode can be changed by entering the Program
Station Passcode feature code at the phone or when using the
Remote Programming feature.
Queue Request 6Requests (or cancels) an automatic callback when a busy trunk or
phone becomes available.
Record-A-Call 385 If the system is programmed with a Record-A-Call application, the
phones can be programmed to use the Record-A-Call feature. It
allows users to enter a feature code whenever they want to record
an ongoing call in their designated Record-A-Call mailbox. Users
can retrieve the recorded messages later, just as they would any
other mailbox messages.
Redial 380 Redials the last outside phone number dialed or saved at the
phone (up to 48 digits). Also used to save numbers at phones
programmed for last number saved.
Redirect Call 331 Allows the phone user to route ringing outside, intercom, and
camped on calls to another phone, hunt group, or outside number.
Routing of the redirected call is still subject to trunk and toll
restrictions. This feature provides these options in addition to the
currently available options which allow the phone user to redirect
calls to Voice Mail or Do-Not-Disturb.
Reminder Message
Reminder Message Cancel 305
306
(Not used on single line phones) The phone user can set reminder
messages that signal the phone at specific times. Or, the user can
cancel all reminder messages for the phone.
Remote Configuration – Disable 343 Reserved for controlled introduction. Disables the Remote
Configuration feature. The VPN connection from the Remote
Proxy Server to the 5000 CP is terminated.
Remote Configuration – Display
License Key 347 Reserved for con trolled introduction. Displays the license key ID
(HASP key) for the 5000 CP.
Remote Configuration – Enable 342 Reserved for controlled in troduction. Enables a Remote
Configuration session. The Virtual Private Network (VPN)
connection from the 5000 CP to the Remote Proxy Server is
initiated.
Remote Configuration – Reset 344 Reserved for controlled introduction. Resets a Remote
Configuration session. The VPN connection from the 5000 CP to
the Remote Proxy Server is reset.
Remote Programming 359 Allows a user to place a phone in DND mode, forward the phone’s
calls, or change the passcode; either from another phone or
through DISA.
Reverse Transfer (Call Pick-Up) 4Picks up a call ringing or holding at a phone or hunt group.
Review Keys 396 (Not used on single line phones) User-programmable feature
buttons and Station Speed Dial buttons can be viewed using this
feature code.
Table 12: Phone Feature Codes (continued)
Feature Name Code Definition
Page 5 of 6